Shenzhenhuazhifazhankejiyouxiangongsi O-07 Fast Wireless Charger Instructions
- June 6, 2024
- Shenzhenhuazhifazhankejiyouxiangongsi
Table of Contents
Instructions
- Connect the USB cable port to the power adapter and then plug the other side into the type-c port of the charging pad.
NOTES
- A lower power may result in longer charging time, charging errors, or lower efficiency of charging. Charging with a QC2.0/QC3.0 adapter is highly recommended.
- Put the mobile phone on the charger pad, the LED light will turn green and start charging your phone, as shown below.
Specification
Product Name: Fast Wireless Charger
Input:DC5V/2A 9V/1.67A
Input Port: Type C
Output power:Max 15W
Model:O-07
Color:Black
Caution
- Please keep the charger away from water or other liquid.
- If you need to clean the charger, please make sure it is not connected to the power supply.
- Do not place too close to magnetic stripe or clip card(ID card, bank cards, etc)to avoid magnetic failure.
- Ensure to properly place the center of the phone’s back in the position shown in the manual.
- Remove any metal foreign material between the wireless charger and the phone as they can cause the device not to charge properly.
- Some kinds of too thick bank covers may also halt the wireless charging. Please check the back cover of your phone, or remove the back cover and try to charge again.
- If your phone has no built-in wireless charge receiver, when installing 3rd party wireless charging cards, be sure that it is installed correctly.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there Is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver Is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Statement
To maintain compliance with FCC’s RF exposure guidelines, This equipment should be installed and operated with a minimum distance of 20cm the radiator your body. This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter