MOMIMO 40727540 Wireless Remote Turn Signal User Manual
- June 6, 2024
- MOMIMO
Table of Contents
MIMO 40727540 Wireless Remote Turn Signal
User Manual
Function Description:
Remote control: a total of 4 buttons, each button is equipped with an indicator.
Product features:
- Large visual range.
- Easy to install.
- Built-in 900mAh rechargeable battery, long life
- The surface waterproof effect reaches ipx2 to ensure daily use.
- High quality led to ensure the warning effect.
The operation method of tail lamp:
- When charging, please remove the tail lamp, open the protective cover of the rubber charging port on the back of the tail lamp, and plug in the micro plug for the USB charging cable.
- The lamp and remote control are matched at the factory and can be used after installation.
- The tail lamp and controller are combined with the corresponding accessories, and then respectively installed in the appropriate position of the vehicle.
- When the battery is replaced after the match is forgotten because the battery is exhausted, long-press the main light switch and remote control switch for 3 seconds at the same time.
Matters needing attention:
- Don’t disassemble and refit without permission.
- This product is only rainproof, do not soak the product in water.
- After use, please turn off the tail light switch button to avoid battery power loss.
- Pay attention to the battery inside the tail lamp, and do not replace it by yourself.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by the manufacturer could void your authority to operate this
equipment. This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>