CONAIR HUM01 Ultrasonic Cool Mist Humidifier Instructions
- June 6, 2024
- ConAir
Table of Contents
CONAIR HUM01 Ultrasonic Cool Mist Humidifier
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, especially when children are present,
precautions should always be taken, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE
DANGER – Any appliance is electrically live even when the switch is off.
- The appliance should always be placed on a firm, flat, waterproof surface at least four feet (1.2 m) away from bedside, six inches (15 cm) from the wall and out of reach of patients, children, and pets. Be sure the appliance is in a stable position and the power cord is away from heated surfaces and out of the way to prevent the humidifier from being tipped over.
- Before use, make sure that your outlet voltage corresponds to the voltage stated on the rating label.
- Before use, extend the cord and inspect for any signs of damage. Do not use if the cord has been damaged. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Do not repair or regulate electronic and mechanical properties without authorization.
- Do not place the humidifier on or near a hot gas or electric burner, or in a heated oven.
- The appliance should not be left unattended in a closed room since air could become saturated and leave condensation on walls and furniture. Leave room door partly open.
- Do not cover the mist outlet with foreign objects while the humidifier is in operation. Do not insert foreign objects into any openings of the humidifier.
- Do not aim mist nozzle directly at children, walls, or furniture.
- Unplug the appliance during filling and cleaning. Do not try to refill the water tank or open the tank cover without unplugging it. Failure to comply will result in personal injury. Pull the plug rather than the cord when applying tension to the plug.
- Do not use appliance for other than its intended use.
- Do not use outdoors. The appliance is for indoor, residential use only.
- Do not tilt, move or empty the water tank when the humidifier is on. Please turn the unit off when moving and when cleaning the water tank or appliance. Unplug the appliance when not in use.
- The humidifier should be maintained daily following the operation described in this manual.
- Do not use without all the components in their proper place.
- Do not place any part of this unit in the dishwasher.
CAUTIONS
- Do not use any detergents, gasoline, glass cleaners, furniture brighteners, paint thinners or other dissolving agents to clean any parts. Do not rinse the base under water or immerse it in liquid.
- Excessive humidity in the room will cause condensation on windows and furniture. It is suggested that humidifiers should not be used when humidity is greater than 65%, and excessive humidification may occur if exceeded. If this happens, please turn off the machine.
- Do not plug in or unplug with wet hands.
- Do not run the appliance without water in the water tank.
- Do not allow children to use the appliance without adult supervision.
- This unit is only intended for water. Do not run the unit with any other liquid.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
USER GUIDE
- Plug the appliance into an appropriate power source. After the appliance is plugged in, one beep will be heard and the appliance will be on standby. The power indicator will flash green and the setting indicator will flash purple once.
- Power ON/Power OFF: Press the Power button once and the appliance will start working under the default High setting. The power indicator will light up green and the setting indicator will light up blue.
- A short beep can be heard after each press of a button.
- To switch from High to Low setting, press the setting button once. The indicator light will turn from blue to purple.
- Refill indicator: The power indicator will illuminate in red and the setting indicator will turn off when the water tank is empty. When this happens, turn off the appliance and refill the tank with water. The appliance will revert to its previous setting once the water tank is filled to the appropriate level and the appliance is powered on again.
- Should the tank be removed from the base while in operation, the power indicator will continuously flash green and the setting indicator will flash blue. It is not recommended to remove the tank while the appliance is in use. Always shut your machine off before removing any part of the appliance.
LIGHT COLOR | FUNCTION |
---|---|
Green | Power on |
Red | When water level is low |
Blue | High mist output |
Purple | Low mist output |
FILLING/REFILLING
-
Remove lid from water tank. Lift the water tank off the base and place on a waterproof surface.
-
Fill the water tank with cool, distilled water. Do not fill with warm or hot water. Avoid pouring water into the ventilation holes in the tank.
Do not fill past the Max Fill line. -
Replace the lid by firmly turning back into place.
-
Plug in the appliance to an appropriate power source.
-
You may adjust your settings from High to Low by pressing the setting button once.
-
Dispose of excess water when appliance is not in use. Do this by removing the water tank from the base, removing the lid, and emptying residual water into a sink.
CLEANING AND MAINTENANCE
NOTE: ALL MAINTENANCE SHOULD BE DONE IN THE KITCHEN OR BATHROOM ON A WATER RESISTANT SURFACE
DAILY MAINTENANCE
If the appliance is used as directed, rigorous cleaning will not be required.
- Caution: Always turn off the power switch and disconnect the power cord from the electrical outlet before cleaning
- Remove lid and remove the water tank from the base.
- Empty the water tank of any residual water and rinse. Then wipe the base clean with a clean cloth or towel.
- Do not immerse or pour water accidentally into the base. The base should be kept dry. Should water fall into the base, empty the base in a sink of any residual water, then wipe dry with a soft cloth or towel. Let the base air-dry for 30 minutes before resuming use.
- Should mineral deposits build up on the ultrasonic membrane, gently clean with a vinegar-soaked cotton swab. Failure to keep this unit clean from mineral deposits usually found in hard water will affect the efficiency of the unit.
LIMITED WARRANTY (U.S. AND CANADA ONLY) This 2-year warranty covers defective materials or workmanship for a period of two years from the date of purchase. Any defective part will be, at the discretion of the manufacturer, repaired or replaced at no charge if the appliance has not been tampered with and has been used according to these printed directions. Retain receipt to prove warranty. This warranty gives you specific legal rights as well as other rights that vary from state to state.
ELECTRICAL PARAMETER
Working voltage | 120V/60HZ |
---|---|
Rated power | 22W |
TROUBLESHOOTING
Problem | Possible Cause | Solution |
---|---|---|
Little or no mist | • No water in tank | • Fill water tank |
is produced | • Unit is not level | • Place unit on level surface |
• Mineral deposits | • Gently clean the ultrasonic membrane | |
on ultrasonic | with a vinegar-soaked cotton swab | |
membrane | ||
Water falls into the base | • Water level surpasses Max Fill line |
• Tank may be leaking
| • Wipe base dry with a soft cloth or towel and let stand for 30 minutes
• Do not fill tank past Max Fill line
• Check the tank for any leaks and replace if necessary
White dust accumulation| • Hard water used in tank| • Use distilled water
ENVIRONMENT-FRIENDLY DISPOSAL
You can help protect the environment!
Please remember to respect your local regulations on electronic disposal.
Dispose of nonworking electrical equipment in accordance with your local
recycling and waste removal regulations.
WARNING: NOTE: DO NOT OVERFILL!, add water to MAX FILL Line indicated under the water tank lid, otherwise there will be no mist.
LIMITED TWO-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our discretion) your unit free of charge for
24 months from the date of purchase if the appliance is defective in
workmanship or materials. This warranty does not apply to damage resulting
from commercial, abusive or unreasonable use. Defects that are the result of
normal wear and tear will not be considered manufacturing defects under this
warranty.
To obtain service under this warranty, return the defective product to the address listed on back, together with your purchase receipt. California residents need only provide proof of purchase and should call 1-800-3-CONAIR for shipping instructions. In the absence of a purchase receipt, the warranty period shall be 24 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 24-MONTH DURATION OF THIS WRITTEN, LIMITED WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR
IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of
special, incidental, or consequential damages, so the above limitation may not
apply to you.
This warranty gives you specific legal rights, and you may also have other
rights, which vary from state to state.
FEDERAL COMMUNICATIONS COMMISSION NOTICE
FCC MARKINGS
WARNING: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 18 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SUPPLIER’S DECLARATION OF CONFORMITY
Brand: CONAIR
Model No.: HUM01
Description: Ultrasonic Humidifier
Responsible Party: Conair Corporation,
1 Cummings Point Road, Stamford, CT 06902
1-800-334-4031
Standards: FCC Part 15 Subpart B, ANSI C63.4-2014 This device complies
with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may
cause undesirable operation.
DATE OF ISSUE: 2 Dec 2019
Service Center Conair Corporation Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
For information on any Conair product, call 1-800-3-CONAIR or visit us on the
web at
www.conair.com
Please register this product at
www.conair.com/registration
©2020 Conair Corporation
Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>