Lasko 4924M Oscillating High Velocity Fan Instruction Manual
- June 6, 2024
- Lasko
Table of Contents
Oscillating High-Velocity Fan
Instruction Manual
Since 1906
Used for Model: 4924M
The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction. Children should be supervised to ensure that they do not play with the appliance.
READ AND SAVE THESE INSTRUCTIONS
Read carefully before attempting to assemble, install, operate or maintain the
product described. Protect yourself and others by observing all safety
information. Failure to comply with instructions could result in personal
injury and/or property damage!
This Fan is for residential use only. It is not intended to be used in
commercial, industrial, or agricultural settings.
|
WARNING
|
---|---|---
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, these instructions and warnings should always be followed to reduce the risk of fire, electrical shock, and injury to persons:
Read all instructions before using this Fan.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR PERSONAL INJURY, ALWAYS
FOLLOW THESE IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS:
DO NOT use this Fan to ventilate areas where flammable liquids or vapors
are used, stored, or are present, including paints, gasoline, varnishes, floor
refinishing products, or solvents. ALWAYS read and follow all warnings and
instructions on the containers for these products!
ALWAYS be sure the plug fits tightly into the outlet. When plugs fit
loosely into outlets, they may slip partially out of the outlet and create a
poor connection. This may cause outlets to overheat and create a potential
fire hazard. Outlets in this condition should be replaced by a qualified
electrician.
ALWAYS unplug the power cord when servicing, cleaning, or moving the Fan.
DO NOT use the ON/OFF switch as the sole means of disconnecting power. NEVER
leave children unattended when the Fan is on or plugged in. ALWAYS turn off
and unplug the
Fan when not in use.
BE CERTAIN that the power source for the Power Supply is 120V AC. DO NOT
plug into any other power source.
CAUTION
-
ONLY use the Lasko-provided AC/DC wall adapter.
-
AVOID the use of extension cords, power strips, power taps, outlet-style air fresheners, or other cord-connected devices, as these devices may overheat and cause a fire hazard.
-
DO NOT route power cord under rugs, carpets, runners, or furniture. This may damage the cord or cause it to overheat creating a fire hazard.
-
ALWAYS place the Fan on a stable, flat, level surface while in operation to prevent the Fan from overturning.
-
NEVER insert or allow fingers or objects to enter grill openings while Fan is in operation or injury and/or damage to the Fan may occur.
-
DO NOT block, cover or obstruct airflow to or from the Fan while in operation.
-
DO NOT use this Fan outdoors or near water or wet locations such as a bathtub, pool, or hot tub. Use of this Fan in a wet location may create a shock hazard.
-
DO NOT run cord under carpeting. Do not cover the cord with throw rugs, runners, or similar coverings. Do not route the cord under furniture or appliances.
Arrange cord away from traffic area and where it will not be tripped over. -
NEVER use a single extension cord to operate more than one Fan or another electrical device.
-
DO NOT use this Fan if it has been damaged or is not functioning properly.
-
THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008 ). This Fan is not suitable for use in agricultural facilities including areas where livestock, poultry, or other animals are confined. Please refer to National Electric Code (NEC) Article 547-7 (2008), or applicable state or local codes or standards relating to electrical requirements for agricultural buildings.
-
THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 500 (2008). This Fan is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or local codes or standards relating to electrical requirements for hazardous locations.
SAVE THESE INSTRUCTIONS
Parts Included
Controls
Power/Speed Knob
Set the fan to the desired speed.
3 – High Speed
2 – Medium Speed
1 – Low Speed
0 – OFF
Oscillation Button
Press the Oscillation Button to start and stop the oscillation function.
MAINTENANCE
WARNING
To reduce the risk of electrical shock and fire please observe the
following instructions:
| – Always unplug the cord before moving, servicing, or cleaning.
– NEVER place the Fan in or near water.
– Clean the Fan only with a vacuum equipped with a brush attachment; the
vacuum will remove the lint and dirt from inside the Fan.
---|---
| – NEVER attempt to take apart the Fan.
– Clean the body of the Fan with a soft cloth only.
– NEVER use ALCOHOL or SOLVENTS such as gasoline, benzene, paint thinner, or
other harsh cleaners.
TROUBLESHOOTING TIPS
If your Fan fails to operate, see below for a probable cause and solution:
Be sure the power cord is plugged into a working electrical outlet.
STORAGE: Store the Fan with these instructions, in the original carton in
a cool, dry place.
LUBRICATION: Motor is permanently lubricated.
Manual printed in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>