Minquanxianxinmeimaoyiyouxiangongsi DI-158D-BL 3 In 1 Charging Station Instructions
- June 6, 2024
- Minquanxianxinmeimaoyiyouxiangongsi
Table of Contents
Minquanxianxinmeimaoyiyouxiangongsi
Highest internal frequency: 350kHz Pi, Input: DC 5V2.1A-5V3A Output: DC 5V2A
3 in 1 Charging Station
Model NO. : DI-158D-BL
Part list
Note: If parts in the packing box don’t check with the list, please contact us
in time.
Paddings for iWatch for below sizes:
Recommend using 10W or above adapter (12W adapter is included)
Do not use any adapter less than 10W, since It’s not enough to support 3
devices working at the same time. Otherwise, it works great for Watch and
AirPods, but not for (Phone. Contact us if the adapter not working for 3
devices.
Warm Tips: Reach us by your Amazon order detail page (select “order”, “sold by” or “contact seller”) for a warranty about it.
INSTRUCTION
Press and file up the Phone support
FCC statement:
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
device a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>