OpenEye OE-C7094-AWR 4MP IP Bullet Camera User Guide

: June 6, 2024
: OpenEye

Table of Contents

OpenEye OE-C7094-AWR 4MP IP Bullet Camera
CONNECTIONS
Waterproof Cable
OVERVIEW
INSTALLATION
DEFAULT USERNAME AND PASSWORD
ASSIGNING AN IP ADDRESS
PRODUCT FEATURES
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

OpenEye OE-C7094-AWR 4MP IP Bullet Camera

CONNECTIONS

Waterproof Cable

1	Thread lock cap	4	Rubber “O” ring
2	Rubber plug	5	Camera cable
3	RJ45 enclosure
1	RJ-45	For network and PoE connections
---	---	---
2	BNC	For analog video input
3	Power (12vDC)	Power connection
4*	Audio In/Out	Audio Out is reserved

5*

| ****

Alarm I/O

Copyright ©2021 OpenEye.
All Rights Reserved. Information contained in this document is subject to change without prior notice. OpenEye does its best to provide accurate information but cannot be held responsible for typos or mistakes.

OVERVIEW

INSTALLATION

Apply template sticker to the desired camera location.
Drill anchor holes using included mounting template.
Remove the mounting template.
Insert anchors.
Mount camera.
Connect network cable with included waterproof cable connector.
Adjust camera view.

NOTE : If the camera will be exposed to inclement weather, OpenEye recommends sealing around the camera base or connection to accessory and accessory connection to the mounting surface with outdoor waterproof caulking.

POWER
This camera is compatible with 12vDC and Power over Ethernet (PoE). If you are connecting 12vDC power, verify the polarity of the power connection.

ETHERNET CABLE CONNECTIONS
Connect a network cable to the camera using the RJ45 input and connect the other end of the cable to your network switch or recorder.

DEFAULT USERNAME AND PASSWORD

NOTE : OpenEye IP cameras ship without a default password.

The admin user password can be set using the following methods:

OpenEye recorders running Apex 2.1 or newer will automatically set a new unique password if:
Connected to an M-Series recorder with a built in PoE switch.
Connected to a network switch through the camera network port and selected then added in setup, if a new password has not already been set.
Connect to the camera directly through a Web Browser and follow the onscreen prompts.
Use the Network Camera Manager (NCM) Utility.

NOTE : The NCM software manual can be found at https://www.openeye.net /ncm-manual

NOTE : Refer to your Apex recorder manual or quick start guide for instruction on adding cameras. Passwords must be 9-32 characters including at least two elements of the following three: digits, letters, and special characters.

ASSIGNING AN IP ADDRESS

OpenEye IP cameras are set to DHCP by default. If a DHCP server is not detected after 4 minutes, the camera will default to IP address 192.168.51.2. If you are not using a DHCP server, NCM will allow you to batch conﬁ gure a static IP address. The IP address for the camera network on your Apex recorder is 192.168.51.1.

NOTE : To change this IP address please refer to your Apex recorder manual. Selecting multiple cameras and entering IP address 192.168.51.2 will set an IP address on all selected cameras, starting at 192.168.51.2 and increase per camera.

Open Network Camera Manager.
Select applicable camera(s).
Input starting IP address, Subnet Mask, Gateway, DNS.
NOTE : NCM requires entry in all ﬁ elds
Apply changes.
Wait 60 seconds before refreshing NCM.

CONNECTING TO THE IP CAMERA
To access the camera setup menu, you need to open Network Camera Manager (NCM) utility. NCM is pre-installed on all OpenEye Recorders, and is also available for download on the OpenEye website for installation on your personal computer or laptop.