OpenEye OE-C7032-WR 2MP Mini Dome IP Camera User Guide

: June 6, 2024
: OpenEye

Table of Contents

OpenEye OE-C7032-WR 2MP Mini Dome IP Camera
CONNECTIONS
INSTALLATION
- ETHERNET CABLE CONNECTIONS
- POWER
DEFAULT USERNAME AND PASSWORD
ASSIGNING AN IP ADDRESS
CONNECTING TO THE IP CAMERA
- PRODUCT FEATURES
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

OpenEye OE-C7032-WR 2MP Mini Dome IP Camera

CONNECTIONS

1

| ****

Reset Button

| To restore the camera to factory defaults:

1. Disconnect power for 30 seconds.

2. Reconnect power and wait 30 seconds.

3. Press and hold the reset button for 20 seconds.

---|---|---

2

| ****

MicroSD Card Slot

| Supports up to 128GB microSD card for Edge storage.

Do not add or remove the microSD card when the camera is powered on.

Waterproof Cable

1	Thread lock cap	4	Rubber “O” ring
2	Rubber plug	5	Camera cable
3	RJ45 enclosure

INSTALLATION

Apply template sticker to desired camera location.
Drill anchor holes using included mounting template.
Remove mounting template.
Insert anchors.
Mount camera.
Connect network cable with included waterproof cable connector.
Adjust camera view.
Secure Lid / dome

NOTE : If the camera will be exposed to inclement weather, OpenEye recommends sealing around the camera base, or connection to mounting surface with outdoor waterproof caulking.

ETHERNET CABLE CONNECTIONS

Connect a network cable to the camera using the RJ45 input and connect the other end of the cable to your network switch or recorder.

POWER

This camera is compatible with 12vDC and Power over Ethernet (PoE). If you are connecting 12vDC power, verify the polarity of the power connection.

DEFAULT USERNAME AND PASSWORD

NOTE : OpenEye IP cameras ship without a default password.

The admin user password can be set using the following methods:

OpenEye recorders running Apex 2.1 or newer will automatically set a new unique password if:
Connected to an M-Series recorder with a built in PoE switch.
Connected to a network switch through the camera network port and selected then added in setup, if a new password has not already been set.
Connect to the camera directly through a Web Browser and follow the onscreen prompts.
Use the Network Camera Manager (NCM) Utility.
Username: admin

NOTE : The NCM software manual can be found at https://www.openeye.net/ ncm-manual

NOTE : Refer to your Apex recorder manual or quick start guide for instruction on adding cameras. Passwords must be 9-32 characters including at least two elements of the following three: digits, letters, and special characters.

ASSIGNING AN IP ADDRESS

OpenEye IP cameras are set to DHCP by default. If a DHCP server is not detected after 4 minutes, the camera will default to IP address 192.168.51.2.
If you are not using a DHCP server, NCM will allow you to batch confi gure a static IP address.
The IP address for the camera network on your Apex recorder is 192.168.51.1.
NOTE : To change this IP address please refer to your Apex recorder manual.

Selecting multiple cameras and entering IP address 192.168.51.2 will set an IP address on all selected cameras, starting at 192.168.51.2 and increase per camera.

Open Network Camera Manager.
Select applicable camera(s).
Input starting IP address, Subnet Mask, Gateway, DNS.
NOTE: NCM requires entry in all fields.
Apply changes.
Wait 60 seconds before refreshing NCM.

CONNECTING TO THE IP CAMERA

To access the camera setup menu, you need to open Network Camera
Manager (NCM) utility. NCM is preinstalled on all OpenEye Recorders, and is also available for download on the OpenEye website for installation on your personal computer or laptop.