RAVEMEN PR2400 Wireless Switch Control Headlight User Guide
- June 6, 2024
- RAVEMEN
Table of Contents
PR2400
Quick Guide
- Power button ：Long press for 1 second to turn on and off the machine, single press the button-switch mode
- Dimming button：single click to switch brightness, long press does not release to enter the highest brightness
Bluetooth pairing:
- Turn on the lights, press and hold the power button and the dimming button at the same time for 2 seconds, and the Bluetooth icon on the screen flashes
- Press and hold the power button and dimming button of the remote control at the same time for 2.5 seconds, the remote control will search for the lights and connect. After the connection is successful, the Bluetooth icon will stop flashing and display the fixed Bluetooth icon –
- Wait for 5 seconds to complete the binding. After the pairing is successful, the lights will flash twice to indicate
- Contact pairing operation, when the lights are turned on, press and hold the power button and dimming button of the lights at the same time (or the power button and dimming button of the remote control)
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Statement:This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF exposure compliance statement:
This device has been evaluated to meet the general RF exposure requirement
www.ravemen.cn
Email:bob@ravemen.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>