PETKIT PP130 Fit 3 Smart Activity Monitoring Pet Tracker Instructions
- June 6, 2024
- PETKIT
Table of Contents
PETKIT PP130 Fit 3 Smart Activity Monitoring Pet Tracker
HOW TO USE
Install the battery
Pull the outer cover outward and take out the main unit Use the stick to
pry open the back cover. Install the batteries in the back cover according to
the H+” and “-” indicated in the battery slot (make sure the batteries are
correctly oriented). Replace the back cover. When the device emits three
“beepw sounds, the installation is complete
connect to the App
Download the PETKIT App and complete your register via the App. Go to the
App’s main page and follow the instructions to add the PETKIT FIT 3 and
connect your device
Wear correctly
Adjust the tightness to fit the size of your pet’s neck, then attach the PETKrT FIT 3 around your pet’s neck.
- This product only supports Bluetooth communication.The App can only control the device after a Bluetooth connection has been established.
- This product uses an LR44 model button battery.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference and·
- this device must accept arry interference received, including interference that may cause undesired operation.
FCC warning
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply (h the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radionv technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction. IC
warning English:
This device complies with Industry Canada licence – exempt RSS standard(
Operation is subject to the following two conditions: (1 This device may not
cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>