Shenzhen Misimi Technologies T1 Garage Door Opener Installation Guide
- June 6, 2024
- Shenzhen Misimi Technologies
Table of Contents
Installation Manual
www.solidremote.help
Self-installation assistance / YouTube installation videos
Solidremote 2020 Edition. ML-20_09
Programming Instructions for Garage Door Opener
- Locate the Smart / Learn button on your garage door opener (you will need a ladder).
- Press and release the learn button on the motor unit. The learn indicator will glow steadily for the 30s.
- Within 30 seconds. Press and hold the button you wish to use on the hand-held remote.
Change Button’s Working Mode on Remote
Mode 1 – works with Purple/Red/Orange
Mode 2 – works with Green/Yellow
Important Note: Some learn button colors may NOT be supported by your
remote. Refer to the product listing description for actual compatibility
info.
Buttons A+B are the two buttons with hatching lines illustration on the
manual cover page.
-
Press and hold buttons A+B simultaneously for 3 seconds until LED blinks, then release all buttons.
-
Press and hold the button you would like to change working mode. LED will change to either SOLID (Mode 1) or FLASHING (Mode 2).
-
Release the button (which just changed to a new working mode), try programming it again with the opener.
LED always flashes in step 2 above? Please change battery follow steps on next page -
Release the remote control button when the motor unit light blinks OR two clicks are heard.
-
Your remote is successfully programmed.
HOW TO ERASE ALL CODES FROM MEMORY
Press and hold the learn button on the motor unit for 6 seconds until the
learn indicator light turns off. Note: Use when programming failed due to full
memory or you have accidentally programmed unwanted buttons After erasing. you
will need to program all remotes again
Battery
The LED on your remote will turn dim and show rapid flashes when the battery
is low and needs to be replaced.
To replace the battery, open the case as shown below. Remove circuit board if
necessary. Slide the old battery out of the holder. and replace it with only
3V CR2032 coin cell batteries.
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.