CONAIR FCB10 2-In-1 Skincare Scalp Massager Instruction Manual
- June 6, 2024
- ConAir
Table of Contents
- INSTRUCTIONS FOR USING THE 2-IN-1 SKINCARE SYSTEM
- USER MAINTENANCE INSTRUCTIONS
- INSTRUCTIONS FOR USING BATTERIES
- SUPPLIER’S DECLARATION OF CONFORMITY
- TROUBLESHOOTING GUIDE
- LIMITED ONE YEAR WARRANTY
- IMPORTANT SAFETY INSTRUCTIONS
- SENSITIVITY AND CAUTIONS
- TRUE GLOW® 2-IN-1 SKINCARE SYSTEM
- ATTACHMENTS
- OPERATING INSTRUCTIONS
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
renew • refresh • revive®
true glow
2-in-1 Skincare System
Scalp Massager + Body Exfoliator
For your safety and continued enjoyment of this product, always read the instruction book carefully before using.
INSTRUCTIONS FOR USING THE 2-IN-1 SKINCARE SYSTEM
- Wet your face and neck and apply sufficient cleanser. Also apply a small amount of cleanser to the silicone bristles.
- Attach the detachable comb to the unit if needed.
- Turn the brush on.
- Do not press the brush hard against your skin, as it will reduce the motion and effectiveness. Keep the brush in light contact and flush against the skin.
- Move the brush in a slow, circular motion around your face. NOTE: Do not apply treatment close to the eyes to avoid risk of injury.
- When finished, rinse with water and dry your skin with a towel.
USER MAINTENANCE INSTRUCTIONS
CARING FOR YOUR TRUE GLOW® 2-IN-1 SKINCARE SYSTEM
- After each use, rinse silicone bristles and wipe the device with a damp cloth to remove any oils or lotions used during treatment.
- Clean unit thoroughly each week with warm, soapy water to help remove oil and lotion buildup. Wipe with a dry cloth and store unit in its box or in a clean, dry place.
- Remove scalp massager comb once a week and clean with warm, soapy water to remove residue accumulated during treatment. Allow silicone bristles to air-dry. Store in a clean, dry place.
- Do not use abrasive cleaners for cleaning.
- Do not put unit in dishwasher for cleaning.
INSTRUCTIONS FOR USING BATTERIES
- Always purchase the correct size and grade of battery most suitable for the intended use.
- Replace old batteries of a set at the same time.
- Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel cadmium) batteries.
- Clean the battery compartment by blowing away any debris prior to battery installation.
- Ensure the batteries are installed correctly with regard to polarity (+ and -).
- Remove batteries from equipment that is not to be used for an extended period of time.
- When batteries begin to fail, remove promptly.
BATTERY DISPOSAL
Batteries contain various materials that must be recycled and disposed of
properly. Do not dispose of in the municipal waste system.
FEDERAL COMMUNICATIONS COMMISSION NOTICE
WARNING: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SUPPLIER’S DECLARATION OF CONFORMITY
Brand: True Glow®
Model No.: FCB10
Description: 2-in-One Skincare System
Responsible Party: Conair Corporation, 1 Cummings Point Rd. Stamford, CT
06902 203-351-9000
Standards: FCC Part 15 Subpart B, ANSI C63.4-2014
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. DATE OF ISSUE: 01/03/2019
TROUBLESHOOTING GUIDE
THE BRUSH IS NOT WORKING.| 1. Make sure the contacts in the unit are
clean. See User Maintenance Instructions for cleaning procedure.
2. Make sure the batteries are installed properly.
---|---
THE BRUSH OPERATES AT SLOW SPEED.| Replace the batteries.
LIMITED ONE YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your unit free of charge for 12
months from the date of purchase if the appliance is defective in workmanship
or materials.
To obtain service under this warranty, return the defective product to the
service center listed, together with your purchase receipt. California
residents need only provide proof of purchase and should call 1-800-3-CONAIR
for shipping instructions. In the absence of a purchase receipt, the warranty
period shall be 12 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 12-MONTH DURATION OF
THIS WRITTEN, LIMITED WARRANTY.
Some states do not allow limitations on how long an implied warranty lasts, so
the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR
IMPLIED, WHATSOEVER.
Some states do not allow the exclusion or limitation of special, incidental,
or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other
rights, which vary from state to state.
Please register this product at
www.conair.com/registration
SERVICE CENTER CONAIR CORPORATION
Service Department 7475 North Glen Harbor Blvd. Glendale, AZ 85307
Visit us on the web at www.conair.com
©2020 Conair Corporation Glendale, AZ 85307
FCB10 Models 19PS064650
IB-16563
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, especially when children are present, basic safety precautions should always be taken, including the following:
READ ALL INSTRUCTIONS BEFORE USING THE 2-IN-1 SKINCARE SYSTEM
WARNING To reduce the risk of burns, fire, electric shock or injury to
persons:
- Close supervision is required when this product is used on, by or near children or people with certain disabilities.
- Use this product only for its intended use as described in this instruction booklet. Do not use attachments not recommended by the manufacturer.
- Keep the unit away from heated surfaces.
- Never use while sleeping or drowsy.
- Do not use outdoors or where oxygen is being administered.
- Never operate if the product is damaged.
- Not for use by children. Keep this product out of reach of children.
- Avoid contact with eyes.
- This product is not a toy.
- This product is intended for household use only.
- DO NOT place or store unit where it can fall or be pulled into a tub or sink.
- DO NOT place in, or drop into water or other liquids.
The True Glow® 2-in-1 Skincare System has no serviceable parts. Call 1-800-3-CONAIR for instructions to purchase replacement parts.
SENSITIVITY AND CAUTIONS
SPECIAL CAUTIONS FOR DELICATE AREAS
The True Glow® 2-in-1 Skincare System is a cleansing device that is intended
to help you get clean and healthy-looking skin from head to toe. The True
Glow® 2-in-1 Skincare System is not a medical device and is not intended to be
used to treat any medical conditions such as acne.
If you are under a doctor’s care for any skin condition or if you think you
have very sensitive skin, please consult your physician before use.
Depending on how your skin reacts to treatment, if rash or irritation occurs,
stop use.
We recommend not sharing this device.
Do not use with exfoliation creams with rough or jagged particles.
If you experience any pain or discomfort during use, stop using and consult
your physician.
Do not apply pressure with the brush to the face or scalp. When finished,
rinse with water, and dry skin with a clean towel.
TRUE GLOW® 2-IN-1 SKINCARE SYSTEM
ATTACHMENTS
SCALP MASSAGER: The scalp massager is perfect for helping to remove
buildup and stimulate and exfoliate the scalp. Simply apply scalp massager to
your scalp, moving it around, leaving your scalp feeling new and refreshed.
COMB: This comb attachment not only helps provide a gentle detangling
massage to your scalp, but it also helps with brushing and detangling.
NOTE: Your True Glow® 2-in-1 Skincare System may only include certain
attachments. See retailer for replacement units or call 1-800-3-CONAIR or
visit www.trueglowbyconair.com
WATERPROOF
The True Glow® 2-in-1 Skincare System is water resistant and can be used in
the shower. Cannot be submerged in water.
OPERATING INSTRUCTIONS
NOTE: The True Glow® 2-in-1 Skincare System operates on 2 AAA batteries (not included).
- Remove the battery cover from the unit.
- Install 2 AAA batteries (not included) as per the markings in the battery compartment.
- Slide the battery cover back onto the unit until the battery door is firmly closed.
- Install the detachable comb if desired, pushing it down until firmly in place.
STARTING THE 2-IN-1 SKINCARE SYSTEM
Press the ON/OFF button for 1 second and choose the LOW, MED or HIGH setting.
STOPPING THE 2-IN-1 SKINCARE SYSTEM
Press the ON/OFF button for 1 second to turn off the unit.
ATTACHING AND REMOVING COMB
To attach, align holes in comb withscalp massager “fingers” and press firmly
onto unit until it snaps into place. To remove, hold the rim and pull comb
off.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>