IKEA Faerskhet Bottom Freezer Refrigerator Stainless Steel Instruction Manual
- June 6, 2024
- Ikea
Table of Contents
IKEA Faerskhet Bottom Freezer Refrigerator Stainless Steel Instruction
Manual
Warning!
Before proceeding with installation, read the safety information in the User Manual.
-
Before installation, e.g. reversing the door (if needed), disconnect the power cable plug from the power socket.
-
At every stage of reversing the door (if needed), protect the door from scratching with durable material.
-
The appliance must be earthed. The power cable plug is provided with a contact for this purpose. If the domestic power socket is not earthed, connect the appliance to a separate earth in compliance
with current regulations, consulting a qualified electrician. -
Never install the appliance in a confined space. Always leave enough space around the appliance for ventilation.
-
Serious or fatal crushing injuries can occur from appliance tip-over. Always secure this appliance to the wall using tip-over restraints.
If needed, the upper and lower doors can be reversed to open from the right
side.
Remove all items from the appliance before reversing the doors.
Remove three hinge screws, then remove the top hinge and the hinge pin sleeve.
- Lift the upper door off the center hinge pin, then remove the door.
- Carefully place the upper door on the padded surface to avoid damage.
Loosen two screws. Then remove the center hinge, and remove the pin from the center hinge.
- Lift the lower door off the bottom hinge pin, then remove the door.
- Carefully place the lower door on the padded surface to avoid damage.
On the top of the lower door, do the followings.
- Remove the pin sleeve.
- Remove the pin hole plug.
- Fix both again by swapping the location.
On the bottom of the lower door, do the followings.
-
Loosen the screw.
Then remove the door stop and the pin sleeve. Set aside the door stop. -
On the opposite side, attach the pin sleeve and another supplied door stop then fix both with the screw
-
Remove two screw hole plugs.
-
Loosen two screws. Then remove the bottom hinge.
Remove the pin from the bottom hinge, then fix the pin in the opposite side of the hinge.
-
Fix the bottom hinge with two screws on the left side.
-
Attach two screw hole plugs on the other side.
-
Flip the center hinge over, then fix it on the left side of the cabinet using two screws.
Install the upper door by placing it onto the center hinge on the left side.
On the top left, attach the hinge pin sleeve and the top hinge, then fix with
three hinge screws.
Door reversing is now completed.
Turn two front feet clockwise or anti-clockwise to adjust the height of the
appliance for levelling.
Tilt the appliance for 1/4” (6 mm) from front to back to ensure doors close
and seal properly.
Fix two supplied anti-tip brackets onto the back of the appliance with the screws.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>