ring BHALP031 Video Doorbell Pro Instructions
- June 6, 2024
- Ring
Table of Contents
ring BHALP031 Video Doorbell Pro
SAFETY INFORMATION
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN FIRE, ELECTRIC
SHOCK, OR OTHER INJURY OR DAMAGE.
Your device can withstand outdoor use and has been tested to withstand water
projected through a 6.3mm nozzle at a volume of 12.5 liters per minute and a
pressure of 30 kPa at a distance of 3 meters for at least 3 minutes. However,
your device is not intended for underwater use. To protect against electric
shock, do not intentionally submerge or immerse your device, battery, or
adapter (not included) in water or expose your device or adapter to other
liquids. Do not spill any food or beverages on your device, battery, or
adapter. Do not attempt to clean or polish your device, battery, or adapter
with or expose your device, battery, or adapter to oil, lotion, or other
abrasive substances. Do not expose your device, battery, or adapter to
saltwater or other conductive liquids. Do not expose your device, battery, or
adapter to pressurized water, high-velocity water, or extremely humid
conditions (such as a steam room). If your device, battery, or adapter gets
wet, carefully unplug all cables without getting your hands wet and wait for
it to dry completely before plugging it in again. Do not attempt to dry your
device, battery, or adapter with an external heat source, such as a microwave
oven or a hairdryer. To avoid risk of electric shock, do not touch your
device, battery, or adapter or any wires connected to your device during a
lightning storm while your device, battery, or adapter is plugged in. If your
device, battery, or adapter appears to be damaged, discontinue use
immediately.
Users are required to use a power supply that complies with PS2 or L.P.S. certification and approval. Use only accessories supplied with your device, or specifically marketed for use with your device, to power your device. Use of third-party accessories may impact your device’s performance. In limited circumstances, use of third-party accessories may void your device’s limited warranty. In addition, use of incompatible third-party accessories may cause damage to your device or the third-party accessory. Read all safety instructions for any accessories before using with your device. Protect the device from direct sunlight. Install the device at dry locations and protect it against rain and humidity. The device may not get contact to saltwater or other conductive liquids. The device must be charged only within a building in a dry state.
SAFELY CONNECTING YOUR RING VIDEO DOORBELL PRO 2 TO YOUR HOME’S ELECTRICAL
WIRING
If you install the Ring Video Doorbell Pro 2 where a doorbell is already in
use and you connect the Ring Video Doorbell Pro 2 to your home’s doorbell
electrical wiring, you must turn off the existing doorbell’s power source at
your home’s cir-cuit breaker or fuse and test that the power is off BEFORE
removing the existing doorbell, installing the Ring Video Doorbell Pro 2, or
touching electrical wires. Failure to turn off circuit breaker or fuse so
could result in FIRE, ELECTRIC SHOCK, or OTHER INJURY or DAMAGE.More than one
disconnect switch may be required to turn off the equipment before servicing.
To test whether you have successfully de-energized your existing doorbell’s
power source, press your doorbell sev-eral times to confirm that the power is
off.
If the electrical wiring in your home does not resemble any of the diagrams or instructions provided with Ring Video Doorbell Pro 2, if you encounter damaged or unsafe wiring, or if you are unsure or uncomfortable in performing this installation or handling electrical wiring, please consult a qualified electrician in your area.Only use accessories & power sources with L.P.S. or PS2 certification that are recommended by the manufacturer. Use of third-party accessories may lead to damage to your Ring Video Doorbell Pro 2 or the accessory and may cause fire, electric shock, or injury.
Product Specifications
Device Name: Video Doorbell Pro 2
Model Number: 5AT2S2
Electrical Rating: 16–24 VAC, 40VA max, 50/60Hz
Temperature Rating: -5°F to 120°F (-20°C to 50°C)
RECYCLING YOUR DEVICE PROPERLY
In some areas, the disposal of certain electronic devices is regulated. Make
sure you dispose of, or recycle, your device in accordance with your local
laws and regulations. For information about recycling your device, go to
amazon.com/devicesupport.
Terms of Service and Warranty
By purchasing or using the product, you agree to the Terms of Service found at
ring.com/terms For information on our warranty,
theft protection, and Ring Protect Plans, see
ring.com/legal
For Consumers in the USA
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Pursuant to Section 15.21 of the FCC rules, changes or modifications to a
Product by the user that are not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. The
device meets the FCC Radio Frequency Emission Guide-lines. Information on the
product is on file with the FCC and can be found by inputting such Product’s
FCC ID (which can be found on the device) into the FCC ID Search form
available at fcc.gov/oet/ea/fccid.
The party responsible for FCC compliance is: Ring LLC, 1523 26th St,
Santa Monica, CA USA, 90404
FCC Statment
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an
uncontrolled environment and it also complies with Part 15 of the FCC RF
Rules. This equipment must be installed and operated in accordance with
provided instructions and the antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other antenna
or transmitter. End-users and installers must be provided with antenna
installation instructions and consider removing the no-col-location statement.
For Consumers in Canada
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Information Regarding Exposure to Radio Frequency Energy
This equipment complies with IC RSS-102 RF exposure limits set forth for an
uncontrolled environment.
Radio Frequency Compliance
In order to protect human health, this device meets the thresholds for
exposure of the general public to electromagnetic fields according to Council
Recommendation 1999/519/EC. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter. This equipment
should be installed and operated with a minimum distance of 20 centimeters
between the radiator and your body.
Ring LLC 1523 26th St. Santa Monica, CA 90404 USA
© 2020 Ring LLC or its affiliates.
Ring and all related marks are trademarks
of Ring LLC or its affiliates.
22-002739-01
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>