RUIMA RM-T1 Portable Battery Speaker User Manual
- June 6, 2024
- RUIMA
Table of Contents
RUIMA RM-T1 Portable Battery Speaker
ACCESSORIES
- Cable Cargador Usb – 1 Pieza
- Manual De Usuario – 1 Pieza
INSTRUCTIONS DEL PANEL CONTROL
- USB Port
- TF Card
- DC interface
- AUX input
- ON OFF button
- Signal input button
- Previous/VOL-(Hold for 3 seconds to decrease volume)
- (In FM mode, hold for 3 seconds the device will enter
- Next/VOL+(Hold for 3 seconds to increase volume)
- LED CHARGE STATUS: RED = Charging GREEN = Fully charged
POWER SOURCE
- Please charge the unit at least 4 hours before the first time used.
- Long press the MODO button on the panel to switch on or off the speaker.
CHARGE THE BATTERY
When the battery is charging, the CHARGE STATUS lights red. After the battery has fully charged, the light turns to be green.
- Connect the AC adaptor to the DC IN JACK of the speaker firmly, and plug it into a wall outlet.
- When the battery is fully charged, first disconnect the AC adaptor from the speaker,then from the wall outlet.
- The speaker works normally when charging.
SIGNAL INPUT BUTTON
Press the MODO button on the front panel to select the mode(AUX, USB, TF, BT
OR FM).
PREVIOUS/NEXT BUTTON
By pressing the PREVIOUS/NEXT button on the front panel, you can select a
specific song from the playlist.
PAUSE/PLAY BUTTON
To stop playing the current track, please press the PAUSE/PLAY button on the
front panel. Press it once again to continue playing.
AUX-IN JACK
- Connect an audio cable to the AUX IN JACK of the speaker and to the audio output socket on the external audio devices such as MP3 player, Discman,etc,then select AUX by pressing the MODO button on the control panel
- Play from an external audio device.
USB JACK
Insert USB card directly for playing
POWER SOURCE
FM Operation
In FM mode, press the signal input button on the front panel control to enter
FM, and press the PREVIOUS or NEXT button on the front panel or the remote
control to choose station; long press PLAY/PAUSE button on the front panel
control to search stations automatically.
Bluetooth:
Press the MODO button on panel or the bluetooth button control to select
Bluetooth mode. Simultaneously open the Bluetooth setting on your phone,
tablet or any other bluetooth enabled audio device and select “RM-T1″(no need
to match code),the unit and device will then connected via Bluetooth. Press
the “next song” and “previous song” button on the remote control to select the
song, press” play/pause” button to control the playing status.
FCC Statment
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning : changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment