Hanxuan Helmet Bluetooth Earphone User Manual
- August 26, 2024
- Hanxuan
Table of Contents
Hanxuan Helmet Bluetooth Earphone
Specifications
- Bluetooth name: HB01
- Bluetooth version: Bluetooth version
- Maximum volume tone
- Call ENC
- Power off connect
- Low voltage reminder
- Automatic answering
- Power On/Off feature
Controls
- charging
- Fully charged
- Power-on not connected
- The device is not connected after 5
- After connection
- Click on
- Double click on
- Click down
- Double click
- Hold down or up for 3S
- Hold the up or down key for 1.5 seconds
- Hold down the middle button for 5S
- Low voltage reminder
- Incoming time
- Click the middle button
- Press and hold the middle button for 2S 10S missed connection
Feature
- Power Off
- Volume +
- Next song
- Volume –
- Previous song
- Voice assistant
- Play/pause
- On/off
- Answer/hang up
- Reject a call
- Automatic answering
Lamp effect
- Steady red
- Steady green
- The green light blinks once for 1S
- The green light blinks slowly for 55
- The red light blinks slowly for 5S
- In tow Call ENC
- Bluetooth name HB01
- Bluetooth version
- Power off connect
- Power on/off
- Power low
- Maximum volume tone Sync ringtones
Power On/Off
To power on the device, press and hold the middle button for 3 seconds. The device will indicate power-on with a steady green light. To power off, press and hold the middle button for 5 seconds.
Volume Control
To adjust the volume, use the up or down keys. Press once for volume up, and
press twice for volume down.
Song Control
To play the next song, double-click on the middle button. To play the previous
song, hold the up or down key for 1.5 seconds.
Phone Call Management
To answer or hang up a call, click the middle button once. To reject a call,
press and hold the middle button for 2 seconds.
Voice Assistant
To activate the voice assistant, press and hold the up or down key for 1.5
seconds.
Low Voltage Reminder
The device will indicate low voltage with a slow-blinking red light for 5 seconds.
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, maycause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by the manufacturer could void your authority to operate this
equipment. This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation. This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 0cm between the radiator and
your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>