FIAMMA 02094B07A Carry-Bike Cycle Carrier Ford Transit Custom Instruction Manual
- June 6, 2024
- FIAMMA
Table of Contents
Bicycles carrier
Installation and usage instructions
CARRY-BIKE
Check that nothing has been damaged or deformed during transport.
In the event of doubts or questions concerning the installation, use, or
limitations of the product, contact the dealer. We recommend that the
installation is carried out by qualifi ed personnel and in compliance with
current local regulations.
Mount the bar with the brackets in this position.
Tightening max 1,5 Nm
Rotate the brackets in this position
To hook the Carry-Bike, push down to snap the tube into the brackets.
WARNING!
Do not fully tighten the fork to the tube, leave 2mm space.
In case of problems please contact your local dealer indicating the data on the nameplate.
Read the following instructions and warnings carefully; failure to observe
these installation and usage instructions as well as the laws for driving in
the relevant country may ause severe harm or damage for which the
manufacturer declines all responsibility. Before installation, ensure
compatibility with the vehicle on which the product must be installed.
Checking that the wall/rear door is suffi ciently solid and suitable for
guaranteeing the resistance of the anchoring points is always mandatory. If
not, strength and compliance with the maximum load indicated in the
instructions are not guaranteed and it will be necessary to reinforce these
points
After having positioned the Carry-Bike on the rear axle of the vehicle, the
normal weight distribution on both axles would be modifi ed. This variation
must not exceed the maximum permissible axle load.
Never exceed the maximum permitted length and the total weight of the full-
load vehicle.
Make sure that loading occurs following a correct weight distribution; it must
be uniformly distributed (the heaviest bike must be placed near the wall of
the vehicle) to ensure better stability.
Always give warnings about the presence of the Carry-Bike on your vehicle,
using a clearly signal for leaning loads and, in case of limited rear
visibility, use the additional rear-view mirrors.
Take into account the presence of the Carry-Bike, paying attention during
driving and especially during reversing maneuvers, particularly if you have a
parking assist system. Always comply with speed limits and the Highway Code.
The speed should always be suitable to traffi c conditions and towed load. In
case of use of the bike carrier with tow make sure that the tow hook is always
accessible and the corner mobility of the tow is guaranteed (volume measuring
DIN 74058).
Check periodically the bicycle rack to make sure it is fi rmly attached,
especially during the fi rst ilometers of after long trips to avoid damages of
the Carry-Bike/vehicle. Make sure the belts are not loose and that the holding
brackets have not shifted. Replace worn components immediately.
Make sure that the support brackets are located where they cannot move or
shift sideways. They also must not touch the roof of the vehicle, the hinges
and the corresponding bolts or screws.
While assembling, pay attention not to close the rear door if screws and
brackets of the Carry-Bike are not tightened, the body and the lights of the
vehicle could be damaged.
Make sure that, during rear door opening, the Carry-Bike and/or the Bike-Block
do not touch the roof of the vehicle (raised roof) and/or its opening systems
(pop-up roofs).
During Carry-Bike installation, verify that there is enough distance between
handlebars and/or pedals and the vehicle’s rear windows in order to avoid any
damages of the window van; do not leave accessories attached (bay seats,
baskets, etc) because vibrations could disengage bikes.
In some cases, the rear windscreen wiper may not work due to the presence of
bicycles. Be aware of the brush radius before operating the windscreen wiper.
On this type of Carry-Bike. bike covers are not allowed (Bike Cover).
Depending on the type of bicycles transported, check the correct visibility of
the rear lights.If the visibility is missing, provide a light repeater bar.
It is recommended to rotate the handlebars of bicycles to avoid damage to the
vehicle wall, for which Fiamma declines all responsibility.
Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer
is entitled to the warranty in accordance with local laws and regulations of
the country in which the product was purchased.
https://www.youtube.com/watch?time_continue=1&v=JCDiN2YUXN
Fiamma S.p.A. – Italy
Via San Rocco, 56
21010 Cardano al Campo (VA)
fiamma.com
All rights reserved.
Fiamma S.p.A.
reserves the right to modify at any time, without notice, prices, materials,
specifi cations, and models or to cease production of any model.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>