iessentials IED-WCS Wireless Charger Phone Stand User Guide
- June 6, 2024
- iessentials
Table of Contents
Wireless Charger Phone Stand
QUICK GUIDE
IED-WCS
PRODUCT OVERVIEW
USING THE WIRELESS CHARGER PHONE STAND
- Connect the micro USB cable to the micro USB port on the charging pad
- Plug the USB connector into a USB power adapter (not included)
- Place your smartphone on the phone base either horizontally or vertically and slide the charging pad to the center of your phone. Your device will indicate it is charging.
- If your wireless-enabled phone does not indicate it is charging, adjust the position of your phone and/or the pad slightly until it does.
PACKAGE CONTENTS
wireless charger phone stand
micro USB cable
Quick setup guide
SPECIFICATIONS
Input: DC 5V/2A, 9V/2A
Output: 5W/7.5W/10W
WARRANTY
Questions? Problems? Picked up the wrong item?
Before returning to the Store, please give our customer service team a chance
to help.
Email us at TechSupport@Mizco.com for a
seamless and speedy resolution.
Mizco International, Inc.
Cranford, New Jersey 07016
All rights reserved.
IESSENTIALS is a registered trademark of Mizco International Inc.
WARRANTY INFORMATION FOR ESSENTIALS PRODUCTS, A DIVISION OF MIZCO
INTERNATIONAL, INC.
We warrant all IESSENTIALS branded products against defects in material and
workmanship for one year from the original date of purchase. At our option, we
shall repair or replace the defective unit covered by this warranty. Please
retain the dated sales receipt as evidence of the date of purchase in order to
obtain any warranty service. This warranty is void if the product has been
handled or used in any manner which is inconsistent with the instructions
accompanying the product or the intended use of the product. This warranty
does not cover any damage due to accident, misuse, abuse, or negligence. This
warranty does not extend to equipment used with the product. This warranty is
valid only if the product is used on a compatible device as specified on or
attached to the product package.
Repair or replacement, as provided under this warranty, is your exclusive
remedy. We shall not be liable for any incidental or consequential damages.
essentials hereby expressly disclaim any and all implied warranties of
merchantability and fitness for a particular purpose.
Some states/countries do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitation or exclusion may not apply
to you. Some states/countries do not allow limitations on implied warranties,
so the above limitation may not apply to you. This warranty gives you specific
legal rights, and you may also have other rights that vary from state to state
and country to country.
FCC STATEMENT: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator and your body. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
FCC ID: RZO-IED-WCS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>