aruba EC-S-P Power Supply Unit DC User Guide
- June 6, 2024
- aruba
Table of Contents
Quick Start Guide
EdgeConnect
EC-S-P
EC-M-H
Power Supply Unit, DC
Before You Begin
- Check your packing slip to verify that you have all the necessary items.
- Prepare to install the module in a proper ESD (Electrostatic Discharge) environment.
- Make sure you have a #2 Phillips screwdriver.
General Description
The EC-M-H DC base configuration includes two power supplies. The DC Power
Supply Unit (DC PSU) can replace a faulty power supply.
The EC-S-P DC base configuration includes a single DC power supply. The DC
Power Supply Unit (DC PSU) can be added as a second power supply or to replace
a faulty power supply.
The DC PSU is hot-swappable when added as a second power supply.
Initial DC PSU Installation
-
Insert the DC Cable into the Power Supply
Align and connect the DC cable into the DC power supply (3-pin blue connector – there is a ‘click’ sound when fully engaged). -
Connect the DC Cable to the Power Source
Connect the other end of the DC cable into the corresponding terminals on the user’s power source:
Red –
positive
Black – negative
Green / Yellow – ground
Use the provided cable tie to manage DC cable placement, as required
Replacing a Faulty or Adding a Second DC PSU
-
(Replacing the DC PSU) Disconnect Power Supply
Remove power supply connection by disconnecting the DC cable terminal – while squeezing together the top and bottom of the terminal connector, pull the connector from the power supply. -
Remove the faulty power supply or the power supply blank to add second power supply
When replacing a faulty power supply, press on the dark blue handle and pull the supply out of the chassis.
When adding a second power supply, remove the power supply blank by loosening the thumbscrews with the #2 Philips screwdriver and pulling the blank from the chassis.
-
Remove the Power Supply from the Packaging
-
Insert the New Power Supply
Ensure the power supply is fully engaged in the system. The dark blue latch clicks when the power supply is fully engaged. -
Connecting the DC Power Supply
Refer to the Intial DC PSU Installation steps to insert the DC Cable into the power supply and connect it to the power source.
Aruba
6280 America Center Drive
San Jose, CA 95002
1.877.210.7325 (toll-free in USA)
+1.408.935.1850
www.silver-peak.com/support
© 2021 Aruba, a Hewlett Packard Enterprise company All rights reserved. PN
201778 Rev A
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>