PANORAMA ANTENNA SW3-772 CM[X]-24-58-2[VAR] Series Low Profile MiMo WiFi Antenna Instruction Manual
- June 6, 2024
- PANORAMA ANTENNA
Table of Contents
![PANORAMA-ANTENNA-SW3-772 CM[X]-24-58-2-VAR]-Series-Low-Profile-WiFi- Antenna-LOGO](https://manuals.plus/wp-content/uploads/2022/03/PANORAMA- ANTENNA-SW3-772-CMX-24-58-2-VAR-Series-Low-Profile-WiFi-Antenna-LOGO.png)
PANORAMA ANTENNA SW3-772 CM[X]-24-58-2[VAR] Series Low Profile MiMo WiFi
Antenna 
Introduction
The CM[X]-24-58 range has been designed to provide MiMo dual-band WiFi
coverage in an ultra-low pro le package. The compact, robust low-pro le
housing contains up to four antenna elements with effective isolation and low
correlation covering 2.4-2.5/4.9-6GHz.
The antenna is designed to be ceiling mounted and can be tested on a
conductive or non-conductive panel. Supplied with integral ame retardant CS32
cables (Compliant to UNECE 118 and EN45545-2) and a halogen-free same
retardant radome, the
the antenna is suitable for many environments.
Select a suitable mounting location
The antenna is omnidirectional and should be mounted as centrally as possible
within the desired coverage area. The roof space should be accessible at this
location to permit routing of cables to the wireless device.
Select an at-level location on the desired ceiling which is free from
obstructions and not close to other ceiling-mounted items. Consider downward
projection of antenna and any height clearance issues with low ceilings.
Safety Note
Take care to avoid mounting the antenna in close proximity to metal ceiling
furniture such as girders, joists, and air conditioning units as these objects
may affect the antenna’s performance.
Mount the Antenna
- If the ceiling is constructed with removable ceiling tiles, it may be best to remove the tile, mount the antenna, and then re- t.
- Mark the center position of the antenna location and make a 19mm (3/4”) hole or a 26mm (1.02”) hole (if the antenna is a version fitted with N-type connectors).
- Remove the adhesive pad backing and place the antenna in position.
- Fit washer and nut – tighten to 4Nm. If mounting to a 26mm (1.02”) hole make sure the antenna is centered in the hole if possible.
Routing and terminating coaxial cable(s)
- Route the coaxial cables to the wireless device, taking care to avoid running adjacent to existing wiring or ceiling furniture. Fit coaxial connectors or adapters if necessary.
Commission and test
- Using a suitable antenna analyzer, carry out a VSWR test in each freq. band. The VSWR should comply with the values shown in the datasheet.
- Connect the antenna to the coaxial cable and carry out a system check.
Notices
- European Waste Electronic Equipment Directive 2002/96/EC Please ensure that your old Waste Electricals and Electronics are recycled. Do not throw them away into standard waste..
- RF Safety Note This antenna should be mounted in such a way that no person is within 20cm (8”) of the antenna during use.
- Directive 2011/65/EU (RoHS 2) This product is fully compliant with the RoHS 2 directive. Exemption 6.c applies
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>