IP44 DE CUT ONE Outdoor Wall Light Instruction Manual
- June 6, 2024
- IP44 DE
Table of Contents
IP44 DE CUT ONE Outdoor Wall Light Instruction Manual
cut one instructions for use
- Push main cable through cable entry part of the wall bracket and ensure tight seal.
- Attach wall bracket. Pay attention of position „top“. Use the washer gaskets with rubberized face against to the wall bracket. Seal unused mounting holes.
- Establish ground connection and connect power lines.
- Hook light housing into notch of the wall bracket. Press luminaire to the wall bracket and tight set screws flush and evenly. Avoid pinched cables.
light technology:
230V Power LED / 2700K system performance: 8 W/498 lm EEC
technical information:
operating voltage 230V / 50Hz
protection class
safety class 1
Luminaire is suitable for mounting on normal inflammable surfaces.
conformity mark
maintenance:
Disconnect the electrical installation.
This luminaire contains built-in LED lamps. The LED lamps can be replaced by
IP44.de in case of a failure of the LED. In this case, please get in touch
with your retailer.
dimming:
The luminaire can be dimmed with an approved leading- or trailing edge dimmer. Please contact IP44.de service center for a list of approved dimmers.
care:
Regularly clean luminaire from dirt and deposits. Do not use a high pressure cleaner for cleaning. Please note care instructions at www.IP44.de.
safety:
We point out that the electric connection of light fixtures has to be done by
a certified installer. We assume no accountability for damages which are a
result of non-appropriate
mounting or application of the luminaire. Modifications on the luminaire will
result in loss of warranty.