testo 0560 1915 Wireless Smart Thermometer Instruction Manual
- June 6, 2024
- testo
Table of Contents
testo 0560 1915 Wireless Smart Thermometer
OVERVIEW
INSTRUCTIONS
Approval and Certification
The use of the wireless module is subject to the regulations and stipulations of the respective country of use, and the module may only be used in countries for which a country certification has been granted. The user and every owner has the obligation to adhere to these regulations and prerequisites for use and acknowledges that the re-sale, export, import etc. in particular in countries without wireless permits, is his responsibility.
EU SAR Information
The SAR limit of Europe is 2.0 W/kg. The highest SAR value reported for 0560 1915 under the testing standard for use in hand is 0.275W/kg. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
ISED Warnings
CAN ICES-003(B)/NMB-003(B): This Class B digital apparatus complies with Canadian ICES-003.
RSS-Gen & RSS-247 statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
ISED SAR warning
The highest SAR value reported under this standard during product
certification for use in the hand is 0.450W/kg.
Co-Location:
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
FCC Warnings
Information from the FCC (Federal Communications Commission) For your own
safety
Shielded cables should be used for a composite interface. This is to ensure
continued protection against radio frequency interference.
FCC warning statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. A
shielded interface cable must be used in order to comply with the emission
limits.
Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC SAR warning
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. The
highest SAR value reported under this standard during product certification of
0560 1915 (FCC ID: WAF-05601915) for use when properly worn in the hand is
0.450 W/kg
Co-Location
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>