AUTEL LAR82060037 Dragonfish Charger User Guide
- June 6, 2024
- AUTEL
Table of Contents
AUTEL LAR82060037 Dragonfish Charger User Guide
Registered Trademark
Shenzhen Autel Robotics Aviation Technology Co., Ltd. (hereinafter referred to as “Autel Robotics”) has been registered in China, the United States and in several overseas countries. EVO IITM, Dragon fish™ AutelVoyager™ , Starpoint™ and Autel Robotics® are the registered trademarks of Autel Robotics. The names of the products and companies mentioned in this manual are trademarks respectively held by Autel Robotics.
Copyright
Without explicit written consent of Autel Robotics, no part of this manual may be copied or forwarded in any form or by any means (whether electronic, mechanical, photocopy, recording or other means).
Disclaimer
Thank you for purchasing the Autel Robotics Dragonfish Charger. Please follow
the guidelines in this manual to ensure safe use of the charger. Only adults
18 years and older are permitted to use this product. Keep out of reach of
children when not in use.
If you fail to abide by these safety instructions, Autel Robotics will not
provide warranty service for damages to the product during use, nor will it be
liable for any product damage or loss (whether direct or indirect, legal,
special, accidental or economical (including but not limited to loss of
profit)) during use. Do not use incompatible parts or use any method that does
not comply with the official instructions of Autel Robotics to modify this
product.
The safety guidelines outlined in this manual will show you the steps and
methods to safely utilize the charger. Please ensure that, when using this
product, you do not endanger the personal and property safety of you and
others.
This manual will be updated from time to time. To download the latest version,
please visit www.autelrobotics.com
Introduction
This charger is a smart charger and is capable of charging two aircraft batteries and a ground station at the same time. When it detects that the aircraft battery voltage difference exceeds a certain value, the charger will intelligently start the charge equalization mode. This mode can quickly balance the voltage of the battery during charging.
Using the charger
Follow the steps below to charge the aircraft battery and ground station:
-
Please connect one end of the charger to a 100~240V AC power source, and connect the other end to the aircraft battery, as shown in the figure below.
-
If you want to charge the ground station, please connect the round head wire on the charger to the ground station.
• When the ground station is charging, the red light will stay on and the green light will stay on when it is fully charged.
- While the aircraft battery is charging, the charger’s green light will stay on, and the LED light will flash quickly. When charging starts in equalization mode, the green light will flash slowly. If charging fails, the indicator will be static red. Under such circumstances, you can disconnect the pand try charging again. If the failure cannot be resolved, please contact your local dealer.
- When the battery is fully charged, disconnect the charger from the battery. Moreover, when the battery is fully charged, the LED indicator status will signal as follows:
- The LED indicator on the aircraft battery will be off.
- Whether the ground station is turned on or off, the LED indicator on the ground station is always green.
Warning
- To ensure proper heat dissipation, do not cover the charger when charging.
- Always place the charger in a stable and safe location.
- During charging, try to avoid touching the metal casing of the charger to prevent high temperature burns.
- Metal casing of the charger to prevent high temperature burns.
Specifications
www.autelrobotics.com
©2021-2022 Autel Robotics Co., Ltd. All Rights Reserved
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>