FIAMMA A0098655Z110 Bracket Adapters Instruction Manual
- June 6, 2024
- FIAMMA
Table of Contents
FIAMMA A0098655Z110 Bracket Adapters Instruction
Installation instructions for brackets
Check that nothing has been damaged or deformed during transport.
In the event of doubts or questions concerning the installation, use or
limitations of the product, contact the dealer. We recommend that the
installation is carried out by qualifi ed personnel and in compliance with
current local regulations.
ATTENTION: INSTALLATION ON FIXING KIT
The brackets must always be well-aligned to each other to avoid later
problems; in case they are not, they must be properly shimmed using the
spacers to ensure the alignment. The installation of the awning can occur only
when the brackets are perfectly aligned to the roof of the
vehicle.
Do not completely tighten the
screws
Do not completely tighten the screws
Important : use of SIKA 252 / Dekalin MS-5 / Zucchini MS Super Fast
adhesive is essential for fixing the bracket (brackets).
Tighten the screws fi rmly
When using the awning please follow the instructions of the product.
ATTENTION Periodically check the brackets to make sure they are fi rmly attached (especially after the fi rst kilometers) make sure the bolts are not loose and that holding brackets have not shifted.
Read the following instructions and warnings carefully; failure to observe these installation and usage instructions as well as the laws for driving in the relevant country may cause severe harm or damage for which the manufacturer declines all responsibility. Before installation, ensure compatibility with the vehicle on which the product must be installed. Checking that the wall/roof/rear door is suffi ciently solid and suitable for guaranteeing the resistance of the anchoring points is always mandatory. If not, strength and compliance with the maximum load indicated in the instructions are not guaranteed and it will be necessary to reinforce it these points.
Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer is entitled to the warranty in accordance with local laws and regulations of the country in which the product was purchased.