EKSELANS 310002 GPON Network Terminal 1 GE Port User Manual
- June 6, 2024
- EKSELANS
Table of Contents
EKSELANS 310002 GPON Network Terminal 1 GE Port
Introduction
Description
GPON optical network terminal for SOHO residential and business use. Media
converter compatible with market routers.
Key features
- 1 port 10/100/1000BASE-T Ethernet self-adaptive.
- Compatible with ITU-T G.984.x standard, with all requirements for access to FTTH ultra-wideband networks.
- Maximum downstream speed 2.5 Gbps and upstream 1.25 Gbps.
- Local and remote management. OMCI, Web, CLI and SNMP.
- Full compatibility with all of our OLT EK equipment.
Package content.
- 1 x ONT 1
- 1 x power supply 12v.
Interfaces and LEDs
Interfaces
- PON port: We will connect the fiber cable that comes from the installation.
- Ethernet ports: We will connect the end equipment (PC, SWITCH, printers, etc.).
- Power supply: We will connect the 12v power supply.
- Side reset button: Button to perform factory reset. We will press and hold for about 20 seconds to perform a factory reset.
LEDs
- POWER: It will be green when the power supply is correct.
- PON: Blinking green, the fiber part works correctly. Not blinking the ONT is correctly setup.
- LOS: When turned on with red flicker, the PON does not synchronize. It is suggested to check the status of the installation, the cable itself and the connectors.
- LAN: Slight flicker in green means the port is working properly.
FAQ
- We don’t see the equipment on the OLT: Check the status of the PON LED, if it’s not green and the LOST part is flashing, it means the fibber part is wrong.
- We provision the ONT but we cannot navigate when connecting the PC. Verify that the PON and LAN port are turned on otherwise check the OLT configuration.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>