Shenzhen Boyi Electronics BY510 Watch Charger User Manual
- June 6, 2024
- Shenzhen Boyi Electronics
Table of Contents
User Manual
Thank you for purchasing our Apple watch charger. Please read this instruction manual before use.
Specification
Product Name: Watch Charger
Color: White
Length : 4.9ft / 1.5m
Material : ABS + PC
Current : 2A
Output : 2.5W for iWatch 10W for iPhone
Weight: About 42 g
Operating Temperature: -10 °C -50 °C Ambient
Humidity: 35%-85%
Safety Manual
- When not in use, disconnect it. The wrong charging method can damage the charging
- Always keep away from moisture while charging.
- Be careful to prevent liquids (sweat, drinking water, ) or foreign matter (fine dust, dust, metal pieces, etc.) to adhere to the connector.
- Do not touch the power supply with wet hands.
- Never use a device with worn cables, broken insulation, or broken plugs.
- We recommend charging your Apple Watch with the case removed.
- Do not use or leave the product in a hot place (near a fire, near a stove, etc.) or in a place where flammable gas is generated.
- Do not put the Apple Watch charger in a microwave oven or high-pressure container.
- Do not give a strong impact such as dropping or
- Do not disassemble or refit.
Customer Service
- If you have any problems, please feel free to contact the seller through your order detail page on the Amazon platform.
- We will wholeheartedly provide you with 100% satisfactory service.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.