Shenzhen Denos Trade DNS-T002 Bluetooth USB Adapter Installation Guide
- June 6, 2024
- Shenzhen Denos Trade
Table of Contents
Shenzhen Denos Trade DNS-T002 Bluetooth USB Adapter
Installation Guide
(Take Windows 7 as an Example)
- Connect Bluetooth adapter to computer, when a message pump up says ‘Installing device driver software’, insert our disk which contains a driver file and double click ‘Setup.exe’ to start.
- Select corresponding language, then confirm.
- Select ‘Next’; then, ‘I accept the terms in the license agreement’; and ‘NEXT’ again. Second, assign a destination folder, and click ‘Next’ afterwards.
- Bluetooth Harmony Setting: First, open ‘Discovery Mode’; second, enable/disable SCMS-T; third, select corresponding device type. finally, click ‘Next’.
- Installation wizard complete.
Cell Phone Paring
- Find Bluetooth icon in toolbar, right click ‘Add Bluetooth Device’, then select all devices.
- Click ‘Add Bluetooth Device’ again.
- Double click the device you want to pair with, then start pairing.
- First confirm pairing on your phone end, then click ‘Next’ on computer end.
- Computer and cell phone pairing is done successfully via Bluetooth.
Data Transfer
- Right click the file which you want to transfer and select ‘Send to Bluetooth Device’.
- Select a receiving device, support selecting multi files simultaneously, here we take ‘HUAWEI P7’ as an example, click ‘Next’.
- On your phone end, click ‘Accept’ to start data transfer.
Bluetooth Headset Pairing
- Open ‘My Computer’, select your Bluetooth device.
- Click ‘Add Device’ and then ‘All’.
- Start to search for Bluetooth headset and cell phone.
- Double click corresponding icon of your device to start pairing.
- Pairing with headset is done successfully via Bluetooth.
- Open ‘My Bluetooth Devices’ and find paired Bluetooth headset, double click it.
- Right click ‘A2DP’ icon to set a connectivity.
- Connection with Bluetooth audio is done successfully.
Troubleshooting
Connection with A2DP is done successfully, but there exist no output
signal?
Solution: Open ‘Control Panel’, then ‘Hardware and Sound’ to set voice
settings 
- Click ‘Mange audio devices’ .
- Open ‘Sound’ setting, change defaulted audio output device, next find ‘Bluetooth Headset’ and change setting to defaulted value, than select ‘Save’.
FCC
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>