Shenzhen Denos Trade DNS-5B12 Wireless USB Adapter User Guide
- June 6, 2024
- Shenzhen Denos Trade
Table of Contents
WiFi Adapter (without Driver)
User Guide（For Windows）
Easy Setup:
Plug & Play automatically
Step 1
Connect the USB interface of the WiFi adapter to the computer USB port
(Support USB2.0/3.0)
Step 2
The computer control panel opens the AutoPlay function or checks “Driver_Disk”
to install the driver software 
Step 3
Select the proper file for your system” Windows/Mac” 
Choose your network and enter the password
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.