VapeEZ Stainless Steel PCTG Semi Transparent Oil Cup User Guide
- June 6, 2024
- VapeEZ
Table of Contents
Stainless Steel PCTG Semi-Transparent Oil Cup
User Guide
Specification
Material: Stainless Steel, PCTG semi-transparent oil cup
Size: 20mm20mm96mm
Pod Capacity: 3.5ml
Resistance: 1.2+0.1/-0.1Ω
Voltage: 3.2-4.2 V
Battery Capacity: 850mAh
User Guide
Usage and instructions
Refer to (use graphic)
Open the silica gel in the direction indicated by the arrow in Figure 1, and
do not remove the entire silica gel, as shown in Figure 2. Use a syringe or an
e-liquid bottle to align the oil injection hole for oil injection, as shown in
Figure 3. It takes 10 seconds after the e-liquid is filled Cover the silicone
to prevent oil leakage, as shown in Figure
Bluetooth instructions：
- Bluetooth activation connection: activated when charging (activation for the first time or when the phone is replaced), when the charging cable is plugged in to activate the Bluetooth connection, the mobile phone APP software opens the pairing, the red and blue LED lights alternately breathe, and the blue light is always on after the connection is turned off for 3S Means connected
- Bluetooth adjustment power: between 5-11W, Bluetooth adjustment power, with 1W as the gear. After adjusting the power level on the mobile phone APP, the LED light corresponding to the current battery will breathe for 0.5S
- Charging method: When the TYPE-C line is plugged in, the LED light will indicate breathing during the charging process. When the voltage is less than 3.7V, the red light will indicate breathing. When the battery voltage is greater than 3.7V, the blue light will indicate breathing, and the blue light will always be on when the battery is fully charged.
Storage and Others
Long Time Storage
- Products stored for a long time (more than 3 months) must be placed in a dry and cool place. Temperature: 20±5℃ Relative humidity: 65±20%RH
- Do not leave it in a high-temperature environment for a long time during use, as it will easily cause the taste of the atomized liquid to change and oil leakage.
When standing upside down, the smokeless oil should be stopped to avoid scorching.
Handling Instructions
Do not leave it in a high-temperature environment for a long time during use,
as it will easily cause the taste of the atomized liquid to change and oil
leakage.
When the e-liquid visibility is lower than the nozzle level, a second oil
injection is required to avoid scorching;
Due to the limited life of the atomizing core, the product is set to 3
repetitive oiling times in terms of the number of oil injections. If more than
3 times, oil leakage and taste deterioration will occur.
Caution: The user is cautioned that changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Supplier’s Declaration of Conformity
Product name: AXON M
Model number: Larg pro 01-C
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Suppliers Name: Al-Khalifa Group LLC
Suppliers Address: 3990 Valley Blvd Suite A Walnut CA 91789-1531
Suppliers phone number: (909)594-0055
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>