Shenzhen Hangshi Technology HD246-T02 Wireless Keyboard User Guide
- June 6, 2024
- Shenzhen Hangshi Technology
Table of Contents
Shenzhen Hangshi Technology HD246-T02 Wireless Keyboard
Package Content
System
Windows/ Mac/ Android/ iOS
Illustration
The Keyboard Function
Instruction
-
Charge Mode
Connected the keyboard to the USB port with cable for charging.
Indicator light turns red when charging, light off when full charged. -
Device Switch
Turn on the keyboard, tap the device button (1.2.3) can switch device connection.
The upper right corner on the keyboard: II Device 1 (2.4G receiver mode) -
Code Matching Mode
Device 1: Tap device 1 and plug the receiver into USB port(2.4g mode has matched before delivery). You can set as following if it doesn’t work.
Plug the receiver into USB port and press ESC + 3s, then you can match the code.
Device 2: Tap device 2, the corresponding light flashes, then press device 2 (about 3s), the indicator light flashes faster.
The keyboard “BT4.0+2.4G KB” can be searched in your device. You can use the keyboard when connected successfully.
Device 3: Tap device 3, the corresponding light flashes, then press device 3 (about 3s), the indicator light flashes faster.
The keyboard “BT4.0+2.4G KB” can be searched in your device. You can use the keyboard when connected successfully. -
Battery Detection
“Please charge in time when the battery voltage is less than 3.2V (indicator light flashes red).”
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device) pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and) if not installed and used in accordance with the instructions) may cause harmful interference to radio communications. However) there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception) which can be determined by turning the equipment off and on) the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.