Shenzhen Hangshi Technology MD165 Wireless Mouse User Manual
- June 6, 2024
- Shenzhen Hangshi Technology
Table of Contents
Shenzhen Hangshi Technology MD165 Wireless Mouse
Package Contents
- 1 x Wireless Mouse
- 1 x 2.4GHz USB Receiver
- 1 x User Manual
Specification
| Dimensions | 104.8163.6238.53mm |
|---|---|
| Operating Range | < 10 meters |
| Power Source | 300mAh |
| Uninterrupted Work Time | 160 days |
| Button Life | 3 million clicks |
| DPI | 800-1200-1600 |
Product overview
- ON/OFF Switch: Turn on and turn off.
- Storage Slot: 2.4GHz USB Receiver inside.
Pairing Steps
Step 1.
Plug 2.4G USB receiver into the USB port of the computer.
Step 2.
Slide the mouse ON/OFF switch to “ON” to turn on the mouse.
Step 3.
On the bottom of the mouse, click the “Connect” button to choose 2.4G channel.
Power Saving Mode
The mouse will enter sleep mode after being idle for 30 min. Press any key
to wake up.
Power Steps
If there is no light displayed at all, the battery is completely drained.
For this situation, it is time to charge.
Troubleshooting
If you are unable to connect the device to your tablet, please try the following:
- Make sure the device be switched on.
- Make sure the 2.4G USB receiver be inserted into a USB port of tablet.
- Make sure that there’s enough power in the device.
- Make sure the device are within 10m.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.