Ricoh RFICM01 IC Card Reader/Writer Installation Guide

June 6, 2024
RICOH

Ricoh RFICM01 IC Card Reader Writer logo

Ricoh RFICM01 IC Card Reader/Writer

Ricoh RFICM01 IC Card Reader Writer pro

Overview

The product is IC Card Reader/Writer module intended to be embedded into other devices. The product is provided with a USB interface; through control from a host controller, it can transmit and receive data to and from IC card or tag. The following diagram shows a typical setup for IC Card Reader/Writer module ICM-3405U-A.

Ricoh RFICM01 IC Card Reader Writer 1

Installation

Hardware Prerequisites The following section shows the hardware required for the installation.

  • Host system For example PC, Multifunction printer and Manufacturing equipment etc. are connected with the IC Card Reader/Writer module.
  • Regulated DC +5V power supply (USB Bus-powered)
  • Host interface cable

USB micro-B cable Refer to “Host Interface Specifications” about pin assigns.

Ricoh RFICM01 IC Card Reader Writer 2

  • Mounting frame (Plastic frame)
    Please use non-conductive material for mounting frame.

  • Screw (M3×1 or 2)
    Please use non-conductive material for screw.

Hardware Installation Steps

  1.  Turn OFF the power of a host system before starting the installation.
  2.  The IC Card Reader/Writer module consists of the Control PCB and the Antenna PCB.Ricoh RFICM01 IC Card Reader Writer 3
  3. Screw the Control PCB and install it on the equipment. It is possible to attach to the device using the mounting hole.
  4. Attach the Antenna PCB by fixed pawl.Ricoh RFICM01 IC Card Reader Writer 4
  5.  Connect the host system to the IC Card Reader/Writer module using the host interface cable.Ricoh RFICM01 IC Card Reader Writer 5
  6. Turn ON the power of a host system.
  7. Supply power to The IC Card Reader/Writer module. And it should start working.
  8.  Application software can communicate to IC Card Reader/Writer module through USB.

RF Communication Steps

  1. Turn ON the power of a host system.
  2. Supply power to the IC Card Reader/Writer module.
  3. Put the IC card or tag on a communication area.
  4.  Send the configuration command from the host system.
  5. Send the read or write operation command.
  6. Check the response data.

Host Interface Specifications

  • Interface Universal Serial Bus Specification Revision 2.0
  • Data Flow Types Controlled Transfer/Bulk Transfer
  • Transfer rate 12Mbps (Full Speed)
  • Power Supply USB Bus-powered
  • Connector USB micro-B
  • Connector Pin assigns
Pin # Signal Name Remarks
1 VBUS Power(+5V+/-5%)
2 D- Data signal
3 D+ Data signal
4 Reserved Not to be connected
5 GND Ground

Host Connector

Ricoh RFICM01 IC Card Reader Writer 7

Communication Method

| ISO/IEC 14443

Type A

| ISO/IEC 14443

Type B

| ISO/IEC 18092| ISO/IEC 15693
---|---|---|---|---
1| Modulation type| ASK 100%| ASK 10%| ASK 10%| ASK 10%
2| Data speed| 106kbps| 106kbps| 212kbps

424kbps

| 26.5kbps
3| Carrier frequency| 13.56MHz

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals