CAAE 9208A RC Engineering Truck Instruction Manual
- June 6, 2024
- CAAE
Table of Contents
CAAE 9208A RC Engineering Truck
OVERVIEW
Instruction
-
NON-RECHARGEABLE BATTERIES ARE NOT TO BE RECHARGED.
-
ONLY BATTERIES OF THE SAME OR EQUIVALE N T TYPE AS
RECOMMENDED ARE TO BE USED. -
BATTERIES ARE TO BE INSERTED WITH THE CORRECT POLARITY.
-
EXHAUSTED BATTERIES ARE TO BE REMOVED FROM THE TOY
-
THE SUPPLY TERMINALS ARE NOT TO BE SHORT-CIRCUITED.
-
DO NOT USE RECHARGEABLE BATTERIES.
-
DO NOT MIX OLD AND NEW BATTERIES.
-
DO NOT MIX ALKALINE STA NDARD (CARBON ZINC), OR
RECHARGEABLE (NICKEL-CADMIUM)BATTERIES.
MULTIFUNCTION
AUTOMATIC PRESENTATION
FCC Statment
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: ( l) this device 111ay does not cause
harmful interference, and(2) this device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
theparty responsible for compliance could void the user’ s authority to
operate the equipment.
NOTE : This equipment has been Lesled an<l fuun<l Lo currently which Lhe
limits Cura Class B <ligiLal <levice, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference ·will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off a don, the user is encouraged to try to correct the
interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected. -
Consult the dealer or an experienced radio/TV technician to help
The device must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>