Vibe FB-BAPP Changing Light Bulb User Manual

Vibe FB-BAPP Changing Light Bulb

Thank you for purchasing the Vibe™ Color Changing Light Bulb with App Control. Please read all instructions carefully before using and retain this manual for future reference.

SAFETY INSTRUCTIONS

• Keep the unit away from heat sources, direct sunlight, humidity, water and any other liquids.
• Do not operate the unit if it has been exposed to water, moisture or any other liquids to prevent against electric shock, explosion and/or injury to yourself and damage to the unit.
• Do not use the unit if it has been dropped or damaged in any way.
• Repairs to electrical equipment should only be performed by a qualified electrician. Improper repairs may place the user at serious risk.
• Do not puncture or harm the exterior surface of the product in any way.
• Keep the unit free from dust, lint, etc.
• Do not use this unit for anything other than its intended use or purpose. Doing so may damage the device.
• This product is not a toy. Keep out of reach of children.

CAUTION

Risk of Electrical Shock- Use in Dry Locations Only. This device is not intended for use with emergency exit fixtures or emergency exit lights.

SPECIFICATIONS

• Socket Type: E26 Standard

• oltage: AC I 00-240V

• Wattage: l. SW

• Light Color: RGB

• Light Source: SMD 5050

• Dimension: 1.93 in. x 3.08 in.

• Remote Battery: CR2025 [Battery included with remote)
  Remove safety strip before use.

• FCC ID: 2AANZBAPP

CARE AND MAINTENANCE

• Do not expose the bulb to liquid, moisture, or humidity to avoid damage to the product’s internal circuitry.
• Do not use abrasive cleaning solvents to clean the unit.
•  Do not expose the bulb to extremely high or low temperatures as this will shorten the life of the electronic device, destroy the battery, and/or distort certain plastic parts.
• Do not dispose of the bulb in fire as they may explode or combust.
•  Do not expose the bulb to contact with sharp objects as this will cause scratches and damage.
• Do not let the bulb fall from high places, as doing so may damage the internal circuitry.
• Do not attempt to disassemble the bulb. In the event that the bulb does not function properly, return it to the store where it was purchased.

PREPARING THE REMOTE CONTROL

The battery has been pre-loaded into the battery compartment for your convenience. When using the remote for the first time, pull out the insulation sheet.

REPLACING THE BATTERY IN REMOTE

Remove the rear battery compartment door and open the battery compartment.

Insert a new CR2025 battery into the compartment by matching the correct polarity. Replace the battery compartment and secure door with a screw.

NOTES

If you are not using the remote for an extended period of time, remove the battery to prevent corrosion in the event of battery leakage. When disposing of batteries, please toke into account the protection of the environment and strictly follow your local laws and regulations fo di r sposal of these batteries.

CAUTION

•  Do not dispose of batteries in a fire, as doing so may cause them to
  explode or leak.

• Batteries must not be exposed to excessive heat such as sunlight, fire, r other similar things.

•  risk of explosion if the battery is replaced with an incorrect type. Use ly an identical battery or equivalent.

BULB MODES & CONTROLS

After you install your bulb, you can choose your own light color, light mode and brightness. The four pre-programmed modes changes colors automatically:

• Flash
• Strobe
• Fade
• Smooth

WARNING: TO AVOID BATTERY LEAKAGE

1.  Be sure to insert the battery correctly, and always follow battery manufacturers’ instructions.
2.  Always remove a weak or dead battery form the product.
3. Remove the battery if the product is left unused for a long period of time.

FCC Statement

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>