U-ANGEL H100BWA Wireless Power Bank User Manual
- June 5, 2024
- U-ANGEL
Table of Contents
H100BWA
User Manual
Introduction
The product with PD, QC3.0, and wireless function, supports Apple Watch wireless charging. It’s our company’s private model, with appearance patent, built-in high capacity battery. It uses intelligent MCU control to achieve fast charging of mobile phones by adjusting different output voltages and currents. Support wireless charging at the same time
Product information
| Input | Lightning: 5V/2A, 9V/2A Type-C:5V/3A, 9V/2A |
|---|---|
| Output | **Wireless charge: 15W/10W/7.5W/5W |
Wireless For Watch: 5V/300mA
USB-A:5V/3A, 9V/2.22A,12V/1.5A
Type-C: 5V/3A, 9V/2.22A,12V/1.5A
Material| ABS+PC
Battery| Polymer lithium battery
Capacity| 10000mAh
Net weight| 226g
Size| 14570.517.4mm
Use temperature| 0-45°C
Transport & temperatures| -20∼50°C**
Product Sketches
Methods of use
1). Wireless charging Part
After pressing the power to open the key, the wireless charging function
starts, the red LED flashes, the mobile phone with wireless function is placed
in the wireless charging area, the Blue LED light up, and the cell phone
displays the charging identifier. The product’s wireless charging function can
only be used when connected to the external power supply
After long pressing the power to open the key, the Low- Voltage wireless charging function for Apple Watch starts, the red LED lights up, the Apple Watch is placed in the wireless charging area, the red LED light-up always, and the Apple Watch displays the charging identifier.
2). Wired charging
Connect one end of the USB line (USB-Micro/USB-Type C/Type C-Type C cable with
the fast charge function) with the output interface of this product, the other
end
connected to the mobile phone or other equipment, press the power key, that is
to start charging. The Green LED light up, and the fast charging function
start.
DC input for this product
The data line Lightning / Type-C ends up with the input interface, the other
end is connected with the QC 3.0 or PD type adapter to charge the product, the
Green LED light up, and the fast charge function start.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.