Shenzhen Oranth Technology Develop TX6S Android TV Box User Manual
- June 5, 2024
- Shenzhen Oranth Technology Develop
Table of Contents
Shenzhen Oranth Technology Develop TX6S Android TV Box
Network
Wi-Fi
- Check “Wi-Fi”, System will start scanning available wireless access points around you automatically.
- Choose an access point and enter the password.
- After authenticating IP address will be given to the box and “connected” is shown, wireless connection is available now.
Notice: Wi-Fi connection and Ethernet connection are mutually excluded.
Ethernet
- Box will automatically stop Wi-Fi connection and Up
- Ethernet connection at the moment when Ethernet jack is plugged in.
- When the IP address appears, the network connection is available.
Upgrade Steps
- Copy OTA zip file into TF card or USB storage device.Insert HD cable and TF card(USB storage device) with the box.\
- Connect the other side of the HD cable to the TV HD port.
- Insert a stick into the hole below the device . There is a reset button inside the hole. And keep pressing the button.
- Insert power adapter. (Still pressing the button)
- Pressing the reset button and hold until you see the android reboot. And use the remote to choose “apply update from EXT”¢ choose “Update from TF card”(choose “Udisk” if USB storage device is applied)¢ choose “xxx.zip (theupgrade package file)” and press OK.
- You will see “-install/ SD card … ” It means the box is upgrading. After upgrade, you can see “Install from SD card complete” at the bottom.
- Use remote to choose “reboot system now” and press OK Or plug the power adapter again to reboot the box.
- Upgrade finished. You can see the “Welcome” interface.
Tips: You can check the build number in settings to confirm you have updated the box successfully.
Trouble Shooting
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could
void the user’s authority to operate the equipment. This equipment has been
tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Statement
To maintain compliance with FCC’s RF Exposure guidelines, This equipment
should be installed and operated with minimum distance of 20cm the radiator
your body. This device and its antenna(s) must not be co-located or operation
in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>