Hangzhou Great Star Industrial IM040304 Remote Control Switch User Guide
- June 5, 2024
- Hangzhou Great Star Industrial
Table of Contents
Great Star Industrial IM040304 Remote Control Switch
User Guide
WIRELESS REMOTE CONTROL E26 LIGHT BULB SOCKET & LAMP SWITCH KIT USER GUIDE
Spec:
Remote control socket
- Base Type: Standard E26
- Working voltage: 120VAC/60Hz
- Maximum load: 40W
- Wireless protocol: 433.925MHz
- Working temperature: 0~40¥
- Size: Die 60MM x 62mm
- Model No. : IM040303
Remote control switch
- Power: 3V(CR2032x1 included)
- Wireless protocol: 433.925MHz
- Working temperature: 0~40¥Max
- Remote Control Distance: 35 meters.
- (Free Area) size: 70mm 115mm* 14mm
- Model No. : IM040304
How to use:
- Install the remote control socket to the present standard E26 socket. Install the light bulb onto the remote control socket.
- Mount the remote control switch to the wall mount or stick the switch anywhere you like.
How to pair?
- Power the socket.
- Long press the set button for 2 seconds. The button flashes blue slowly indicating the socket entered pairing mode.
- Press the switch to pair. The button flashes 3 times indicating the switch and the socket paired succeed.
- Socket will quit the pairing mode if no switch has been paired in 30 seconds. Or you may quit pairing mode by pressing the set button.
How to unpair?
Long press the set button for 10 seconds to unpair all the switches that are paired to this socket. The button flashes 3 times indicates the switch and the socket are unpaired succeed.
Pairing options
We have 2 optional control kits available for you.
a. Multiple switches control one socket. ( max 10 switches )
b. One switch controls One socket.
FCC Statement
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
ISED RSS Warning: This device complies with Innovation, Science, and
Economic Development Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>