nedap VP1004-B RFID Solution for Dairy Instruction Manual
- June 5, 2024
- nedap
Table of Contents
nedap VP1004-B RFID Solution for Dairy
Copyright
Copyright © Nedap N.V. All rights reserved. The information in this document
is subject to change without notice, it is not to be reproduced in any way, in
whole or in part, without the written consent of Nedap N.V. All trademarks
referenced belong to their respective owners.
Disclaimer
Nedap N.V. has made every effort to ensure the accuracy of the information
contained in this document. However, Nedap N.V. makes no representations or
warranties whatsoever whether express or implied as to the accuracy,
correctness, completeness or fit-for-purpose or suitability for the purpose of
this product. You use the products at your own risk. Nedap N.V. excludes any
liability to the maximum extent permitted by applicable law for the damages
caused by errors or failures made during the installation or improper use of
this product or by not applying the instructions stated in this document.
Nedap N.V. reserves the right to make improvements or amendments to this
document and/or the products described therein at any time without any
notification. The latest version of this document can be found on the Nedap
Livestock Management business portal (www.nedap.com/livestockmanagement-
portal). Please download the latest version of this document (by yourself or
reseller) and keep a copy for your own records. This document can be published
in various languages but only the English language version will prevail. Nedap
N.V. assumes no responsibility for any errors caused for the translations into
another language.
Warranty and spare parts
Please consult the Nedap products dealer from whom you purchased this product,
in regards to the applicable warranty conditions. This product cannot be used
for any other purpose as described in this document. If
the product is not installed according to this document; the warranty provided
is not applicable. At the sole discretion of Nedap N.V., Nedap N.V. may decide
to change the conditions of the warranty policy. You agree that Nedap N.V. is
able to compensate you the pro-rata value of the warranty involved rather than
replacing or repairing the product depending on the technical or economical
value of the product. Prior to applying the warranty, please verify if you
comply with the warranty conditions of the warranty policy, whether you can
successfully apply for the replacement or repair of a defective part. Parts
can only be replaced with original Nedap parts, otherwise the warranty policy
will not be applicable on the product. If the warranty is applicable, please
contact the dealer or send the defective parts to the dealer.
Additional information
For any information or questions regarding the product, please contact your own dealer. The installation manual for this product can be found at: www.nedap.com/livestockmanagement-portal
Safety
Read this manual before using this product. Failure to follow the instructions and safety precautions in this manual may result in serious injury or death. Keep this manual in a safe location for future reference.
Symbols used in the manual
- Danger: Indicates a hazardous situation that, if not avoided, will result in death or serious injury.
- Warning: Indicates a hazardous situation that, if not avoided, could result in death or serious injury.
- Caution: Indicates a hazardous situation that, if not avoided, could result in minor or moderate injury.
- Indicates important information but not hazard related
- Suggestions and advice to perform certain tasks more easily.
General safety instructions
Warning
- Always turn off the mains power supply when working on the electrical installation.
- Always wear proper protection when installing and maintaining the VP1004-B.
Caution
- Use the VP1004-B only with a suitable power supply. The power supply or power adapter must comply with local regulations for a SELV, limited power (NEC class2, ps2) output (e.g. Nedap VP2001-B or Nedap power adapter (P/N 9223126)).
- Installation and service should only be done by locally qualified personnel.
- Install the system according to the local rules and regulations.
Working environment
- The installation area must be free from any obstacles, including animals
- Make sure all components are installed out of reach of animals
- Make sure all cables are properly concealed, and form no danger for stumbling.
- Take into account the high concentrations of ammonia when installing and maintaining the VP1004-B in pig barns.
Animal welfare and safety
The automated actions of the Nedap Livestock Management systems do never discharge the installer and the user of the system from his/her responsibility to assure and to take care of the well-being of the animals.
Compliance
FCC and ISED Compliance statement
This device complies with part 15 of the FCC Rules and to RSS-210 of
Innovation, Science and Economic Development Canada. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC and ISED Radiation Exposure Statement
This equipment complies with FCC and Canadian radiation exposure limits set
forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 3
cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
FCC and ISED Information to the user
Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequent energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does not cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver.
This Class B digital apparatus complies with the Canadian standard ICES-003. Cet appareil numérique de Classe B est conforme à la norme Canadienne ICES-003. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. To ensure compliance with FCC regulations, use only the shielded interface cables provided with the product, or additional specified components or accessories that can be used with the installation of the product.
Antennas
This device may be used with the following Nedap antennas: VP6011 and
VP6012.
Disposal
The WEEE symbol in Europe indicates that the relevant electrical product or
battery should not be disposed of as general household waste in Europe. To
ensure the correct waste treatment of the product and battery, please dispose
them in accordance to any applicable local laws of requirement for disposal of
electrical equipment or batteries. In so doing, you will help to conserve
natural resources and improve standards of environmental protection in
treatment and disposal of electrical waste (Waste Electrical and Electronic
Equipment Directive WEEE 2012/19/EU).
CE
Hereby NEDAP N.V. declares that the subject equipment is in compliance with
the directives 2014/53/
EU (Radio Equipment Directive) and 2011/65/EU (Restriction of the use of
certain hazardous substances). The full text of the EU declaration of
conformity is available at our Business Portal: http: / //
www.nedap.com/ livestock management-portal
References
- Technology for life - Nedap
- User account | Nedap Business Portal
- User account | Nedap Business Portal "User account | Nedap Business Portal")
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>