hansgrohe Starck X 10205000 Single Lever Bidet Mixer Instruction Manual

hansgrohe Starck X 10205000 Single Lever Bidet Mixer

Product Information

The product is a shower system that can be used for bathing, hygienic and body cleansing purposes. It has safety instructions and technical data that need to be followed during installation and usage. The recommended operating pressure is 1.6 MPa, and the maximum operating pressure is 1 MPa. The hot and cold supplies must be of equal pressure. The product comes with spare parts, special accessories, and an installation kit that needs to be ordered separately. The product also has a flow diagram and dimensions that can be found on page 34 of the user manual.

Product Usage Instructions

To use the product safely and effectively, follow the below instructions:

1. Wear protective gloves during installation to prevent crushing and cutting injuries.
2. The shower system should only be used for bathing, hygienic and body cleansing purposes.
3. Ensure that the hot and cold supplies are of equal pressure.
4. Do not use silicone-containing acetic acid.
5. Clean the product regularly following the instructions on page 37 of the user manual.
6. Refer to page 38 of the user manual for information on operation and test certificates.

For installation, refer to page 31 of the user manual. Additionally, the product comes with spare parts, special accessories, and an installation kit that needs to be ordered separately.

Models

Safety Notes

• Gloves should be worn during installation to prevent crushing and cutting injuries.
• The shower system may only be used for bathing, hygienic and body cleansing purposes.
• The hot and cold supplies must be of equal pressures.

Installation Instructions

• The fitting must be installed, flushed and tested after the valid norms.
• If the instantaneous water heater causes problems or if you wish to increase the water flow, the EcoSmart® (flow limiter) located behind the aerator can be removed.
• Hansgrohe mixers can be used together with hydraulically and thermically controlled continuous flow heaters if the flow pressure is at least 0,15 MPa.
• This mixer is equipped with a flush stream, which enhances the natural side of the life element water. As this flush stream does not contain any air, we recommend the use of very deep basins to prevent water spray.
• This mixer series is produced with the following spray pattern – with the spray former with a waterfall. For an alternative spray, an aerator with a round monospray, that can changed easily on the spot, is enclosed.

Assembly

Technical Data

This mixer series-produced with EcoSmart® (flow limiter)

• Operating pressure: max. 1 MPa
• Recommended operating pressure: 0,1 – 0,5 MPa
• Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI)
• Hot water temperature: max. 80°C
• Recommended hot water temp.: 65°C

Symbol Description

• Do not use silicone-containing acetic acid!

Dimensions

Starck X
10070000 / 10071000 / 10072000 / 10077000

Flow diagram

1. with EcoSmart®
2. without EcoSmart®

Starck X
10080000/10084000/10205000

Spare parts

Special accessories

• special tool (58085000) order as an extra
• Installation kit order as an extra

Cleaning

Operation

open

close

cold

hot

Test certificate

Hansgrohe
Postfach 1145 · D-77761 Schiltach · Telefon +49 (0) 78 36/51-1282 · Telefax +49 (0) 7836/511440
E-Mail: info@hansgrohe.com · Internet: www.hansgrohe.com.

References

• Taps for bathrooms, showers and kitchens | hansgrohe INT

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>