global sources PZS0010GD Paz Aula Illuminated Bluetooth Speaker User Manual
- June 5, 2024
- global sources
Table of Contents
Paz Aula Illuminated Bluetooth Speaker
PAZ AULA ——
USER MANUAL
CHARGE YOUR AULA
-
Connect the Type-C charging cable to the back of your AULA through any wall charger.
OR -
Place AULA on any wireless charging pad.
-
The LED indicator at the back of the speaker will be steady red during charging,
POWER ON/OFF
- Press and hold the power button for ane second to
tum the power on/off.
BLUETOOTH PAIRING
- It no device is connected to AULA, it will enter pairing mode when you turn on the power: The LED at the control panel will flash in blue during pairing mode.
- The LED will be in steady blue when AULA is connected to a device.
- Press and hold the “BT” button for two seconds will un-pair connected device and re-enter pairing mode.
- When power on, AULA will automatically connect to the lost device which is available.
MUSIC CONTROLS
When playing music
- Play/pause. —- Press “0” button once
- Volume adjustment. —- Press and hold “+/-“
- Next/Previous track. —- Press “+/-” once
Speaker phone(when connect to a smart phone)
- Answer/End incoming call..Press “BT button” once
TWS (True Wireless Stereo) Pairing
- Power on both AULA speakers, press and hold
“0” button on both speakers:
“Beep” sound once : start pairing
“Beep” sound twice : connected
LED of Master speaker will be in steady blue; The
LED on the Secondary speaker will be in flashing blue.
NIGHT LIGHT
Press the “PAZ” button to switch lighting brightness;
100% (Default) > 50% > Off
NOTE
If ni device is connected to AULA during painting
mode, the speaker will be switched off automatically
after3 minutes to conserve battery.
- When connected to a device, if no music is played to 15 minutes AULA will be switched off automatically to conserve battery.
- While playing music and charging at the same time, the battery consumption might exceeds the input power and might affect the charging speed.
Control Panel
Specs:
FEDERAL COMMUNICATIONS COMMISSION
INTERFERENCE STATEMENT ——— PZS0010GD
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF exposure warning
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>