Electron X Gigster I Speaker Box User Guide

: June 5, 2024
: Electron X

Table of Contents

OPERATION
FCC warning:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

GIGSTER I &II

USB / MP3 level control
Play/Pause/Scan/Reception/Auterior/Silent
USB input
SD card input
Mic level control
Line level control
Master volume control
MIC input
EQ control
Mic/Line control knob
Line IN
RCA (R & L) Auxiliary line inputs
Line out
Speaker out
110~220V Voltage control
Power plug
LED control
Power switch

OPERATION

Prior to switching it on, turn the volume down to a minimum.
Connect the audio source to the appropriate input socket.
Another Speaker can be connected to the output socket so that several boxes can be daisy-chained.
Connect to the mains supply.
Switch on the audio source, followed by the active speaker.
Set the volume with the applicable control.
Adjust the bass+treble.
Activate the Bluetooth: Input password”0000” if asked for.

FCC warning:

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 20cm between the radiator & your body.