Electron X W-263A DOMINO Stage Speaker User Manual
- June 5, 2024
- Electron X
Table of Contents
Electron X W-263A DOMINO Stage Speaker
Panel function description
- Microphone Priority Switch
- Mic ECHO adjustment
- USB/SD/MMC Jack
- Five-paragraph EQ
- LED Display
- Audio output
- LED power out
- Vice- box power out
- TUNER Antenna
- AC~220V/50Hz Power input
- LED switch
- Power switch
- Microphone in
- Bass adjustment
- Treble adjustment
- Main volume adjustment
- MIC volume
- Function keys
ATTENTION
- Do not put the product in hot surfaces, prevent from soaking and wet areas.
- Do not open back board, this may void your warranty. Risk of electric shock. For maintenance or repairs should only be done by professionals.
- In case of water spills or rain disconnect immediately.
- Turn power off and disconnect the unit when the system is not in use.
Bluetooth wireless operation
Turn on the speaker, and press the MODE key to switch to Bluetooth MODE, at the same time the speaker emits its Bluetooth pairing name Domino. Turn on your phone or other Bluetooth receiver, and find Domino in the Bluetooth directory, click it to connect. After connecting successfully, there will be audible indication. Playing songs from the Bluetooth device or other audio can be transmitted to the speaker via Bluetooth.
- Built-OCLamplifier.compatible for computer,VCD,DVD,CD,LD,Walkman Etc.
- Low noise design
- power supply:applicable for AC 110V/60Hz
INSTALLATION GUIDE
- Connect the lights to the auxiliary box with the RCA line.
- Connect to secondary box with 6.35 audio interpolation.
- Connect AC power, then turn on the light switch and power switch to play music.
- Load the microphone battery with a 5 # X2 battery, open the microphone, and then adjust the microphone volume and reverberation size for karaoke singing.
USAGE
- Turn the master volume to minimum position when turning on the unit.
- Adjust the equalizer to desired sound. turn clockwise to increase volume.
- Reposition all knobs to minimum position before turning the system off.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.