Dongguan Imlong Electronic YL-WM1807 Wireless Mouse User Manual
- June 5, 2024
- Dongguan Imlong Electronic
Table of Contents
Dongguan Imlong Electronic YL-WM1807 Wireless Mouse
User Manual
-
1 Battery Installation
-
Open the battery cover on bottom of mouse, and pull out the Nano receiver.
-
Put battery in according to the polarity of the battery, then close the cover.
-
Device connection:
-
Put Nano receiver into the computer’s USB port, and ensure good contact。
-
Computer will recognize a USB mouse device.(can be seen from the devicemanager)
-
Turn ON/OFF button (on the bottom of mouse) to “ON” for power on (“OFF” button for power off); there red right on bottom that enter the working state.
-
Moving the mouse, you can enjoy wireless freedom.
-
If the connection failed，connection methods as follows： Turn ON/OFF button to ON, and re-install battery, then replu Nano receiver;Mouse can be work normally.
-
Sleeping mode:
Press any button to wake-up from Sleeping mode -
receiver collection function:
-
For convenient to carry, can put Nano receiver into the collection tank of mouse.
-
Environment condition:
-
Operation temperature:0 ℃～50℃，humidity:20％RH～90％RH without condensations.
-
Matters needing attention:
-
Applications of the mouse will be affected on the rough or reflection surface.
-
Don’t disassemble mouse and receiver
-
Use dry and soft cotton product clean mouse.
-
Careful choice battery. its quality affects operation time and mouse life.
Instructions on battery
Don’t throw the waste battery into recycle bin while replace battery.
FCC STATEMENTS
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following
two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.”
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>