Dongguan Imlong Electronic YL-WM1408 Wireless Mouse User Manual
- June 5, 2024
- Dongguan Imlong Electronic
Table of Contents
User Manual
Model number: YL-WM1408
Battery Installation
- Open the battery cover on the bottom of the mouse, and pull out the Nano receiver.
- Put the battery in according to the polarity of the battery, then close the cover.
Device connection:
- Put the Nano receiver into the computer’s USB port, and ensure good contact.
- The computer will recognize a USB mouse device. (which can be seen from the device manager)
- Moving the mouse, you can enjoy wireless freedom.
- If the connection failed connection methods are as follows ：
Turn-ON/OFF button to ON, and re-install the battery, then reply Nano receiver; Mouse can work normally.
Sleeping mode:
Press any button to wake-up from Sleeping mode
receiver collection function:
- For convenience to carry, one can put the Nano receiver into the collection tank of the mouse.
Environment condition:
- Operation temperature:0 ℃～50 ℃，humidity:20 ％RH ～90 ％RH without condensations.
Matters needing attention:
- Applications of the mouse will be affected on the rough or reflective surface.
- Don’t disassemble the mouse and receiver
- Use dry and soft cotton products to clean the mouse.
- Careful choice battery. its quality affects operation time and mouse life.
Instructions on “wireless ”
The transmission frequency is 2.4GHz, it meets RE Directive 2014/53/EU noun in
Europe and its radiation does not harm the human body. (far less than the
mobile phone’s radiation)
Instructions on battery
Don’t throw the waste battery into recycle bin while replacing the battery.
FCC STATEMENTS
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.”
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>