packard bell N1000 CloudBook 10.1 inch Windows 2 in 1 Computer Tablet Laptop User Guide
- June 5, 2024
- packard bell
Table of Contents
cloudBook®
Quick Start Guide
N1000
In the box
Buttons and ports
1. Power button
2. Volume buttons
3. Front camera
4. Rear camera
5. Microphone| 6. Headphone jack
7. USB type C (data only)
8. Mini HDMI
9. USB port
10. DC charger port| 11. Micro SD card slot
12. Stereo speakers
13. Touchpad
14. Pogo pins
---|---|---
Getting started
POWER ON: Press and hold the POWER button until the tablet turns on.
LOCK: Briefly press the POWER button to lock the tablet.
POWER OFF: Select Start > Power > Shut down.
Note: The device should be shut down through the Windows OS as shown above. However, if you need to force the device to shut down, press and hold the POWER button until the display turns off and the device shuts down.
After completing the Windows setup, the home screen will be displayed.
Keyboard dock
- To dock the tablet to the keyboard, align the tablet and the keyboard, then slide the tablet into the dock as shown below.
- To undock the tablet from the keyboard, firmly hold the keyboard as shown below, then gently pull the tablet upwards.
Note:
- The tablet will automatically recognize the keyboard when docked properly.
- If the tablet is wrongly docked then it may damage the keyboard or tablet.
Using the touchpad
The touchpad provides the functionality of a mouse. It has a touch-sensitive surface that senses the motion and position of your finger(s).
IMPORTANT
The touchpad does not have a mechanical click. Tap to select.
Scroll:
Place two fingers on the touchpad and slide them to scroll in any direction on
the page or program
Zoom:
Place two fingers on the touchpad and then move them apart or closer to zoom-
in or zoom-out.
Switch program:
Place three fingers on the touchpad and swipe to either side to switch between
open windows and programs.
Function/Shortcut keys
To access the shortcuts of the Function keys, F1 through F12, press & hold the Fn button and select the desired Function key.
Expanding the storage
Inserting a Micro SD card
The tablet supports Micro SD cards up to 256GB (not included).
To install a Micro SD card into the tablet, gently open the cover and
carefully insert the card as shown below into the card slot until it clicks
and locks into place.
To remove the Micro SD card, gently press it inward to eject.
USB, Type C, and HDMI Ports
You can connect a USB stick, mouse, or monitor to the tablet’s USB and HDMI
ports.
The included OTG cable allows you to create an additional USB port via the
Type C port of the tablet.
To connect the tablet to a TV or monitor, use a mini HDMI to HDMI cable (not included)
Windows 10 S Mode
Your laptop is shipped with Windows 10 S Mode which is a version of Windows 10 that’s streamlined for security and performance, while providing a familiar Windows experience. To increase security, it allows only apps from the Microsoft Store, and requires Microsoft Edge for safe browsing.
For more info, visit https://www.microsoft.com/en-us/windows/s-mode
Switching out of S mode
To increase security and performance, Windows 10 in S mode runs only apps from
the Microsoft Store. If you want to install an app that isn’t available in the
Microsoft Store, you’ll need to permanently switch out of S mode. There’s no
charge to switch out of S mode, but you won’t be able to turn it back on. To
switch out of S mode follow the steps below.
-
On your PC running Windows 10 in S mode, open Settings > Update & Security > Activation.
-
Find the “Switch to Windows 10 Home” or “Switch to Windows 10 Pro” section, then select “Go to the Store.”
Note: Don’t select the link under “Upgrade your edition of Windows”. That’s a different process that will keep you in S mode. -
On the page that appears in the Microsoft Store (Switch out of S mode or a similar page), select “Get.” After you confirm this action, you’ll be able to install apps from outside the Microsoft Store.
Legal information
FCC Part 15:
This equipment has been tested and found to comply with the requirements for a
Class B digital device under Part 15 of the Federal Communications Commission
(FCC) rules. These requirements are intended to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Re-orient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Do not attempt to repair or modify this equipment.
Warning: Changes or modifications to this equipment not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
“This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.”
Shielded USB cables must be used with this unit to ensure compliance with the Class B FCC limits.
Information Regarding Exposure to Radio Frequency Energy
Your device is designed and manufactured not to exceed the emission limits for
exposure to RF energy set by the Federal Communications Commission of the
United States (FCC). Information on your Device is on file with the FCC and
can be found under the Display Grant section of http://www.fcc.gov/oet/ea/
after searching on the FCC ID for your Device, which can be found on the back
of the Device. If your electronic device has internal memory on which personal
or other confidential data may be stored, you may want to perform a data
sanitization process before you dispose of your device to assure another party
cannot access your personal data. Data sanitization varies by the type of
product and its software, and you may want to research the best sanitization
process for your device before disposal. You may also check with your local
recycling facility to determine their data sanitization procedures during the
recycling process.
Specific Absorption Rate (SAR)
This device meets the government’s requirements for exposure to radio waves.
The Specific
Absorption Rate (SAR) limit set by the FCC is 1.6W/kg. The highest SAR value
reported to the FCC for this device is 1.358W/kg and complies with this limit.
IC Statement
This device complies with Industry Canada license-exempt RSS standard(s)
Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. End user must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter.
These requirements set a SAR limit of 1.6 W/kg averaged over one gram of
tissue. The highest SAR value for this model phone when tested for use at the
ear is 0.532 W/Kg and when worn on the body is 1.054 W/Kg. This device was
tested for typical body-worn operations. To comply with RF exposure
requirements, a minimum separation distance of 10mm must be maintained between
the user’s body and the handset, including the antenna. Third-party belt-
clips, holsters, and similar accessories used by this device should not
contain any metallic components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and should be
avoided. Use only the supplied or an approved antenna.
Battery Disposal & Recycle
This device contains a Lithium-ion battery. The battery must be recycled or
disposed of properly.
Contact your local waste management office for information on battery
recycling or disposal.
1-800-822-8837
Designed and distributed by Southern Telecom Inc. Brooklyn, NY 11220
© 2020 All Rights Reserved.
Packard Bell® is a registered trademark of PBX Holding LLC.
All other trademarks and trade names are those of their respective owners.
Images simulated and may difier from the actual product.
1-Year Limited Warranty
Territory: United States/Canada
LIMITED WARRANTY TO ORIGINAL CONSUMER
This product (including any accessories included in the original packaging) as
supplied and distributed new by an authorized retailer is warranted by
Southern Telecom, Inc. to the original consumer purchaser against defects in
materials and workmanship (“Warranty”) as follows:
To obtain warranty service:
Visit our website at www.southerntelecom.com
Click on Product Support
Select the Brand of your device
Select Service Request and fill out the form to begin your inquiry
Your product will be repaired or replaced, at our option, for the same or similar model of equal value if examination by the service center determines this product is defective. Products received damaged as a result of shipping will require you to file a claim with the carrier.
Warranty service not provided
This warranty does not cover damage resulting from accident, misuse, abuse,
improper installation or operation, lack of reasonable care, unauthorized
modification including software modifications such as the installation of
custom firmware. This warranty is voided in the event any unauthorized person
opens, alters or repairs this product. All products being returned to the
authorized service center for repair must be suitably
packaged.
NO WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY
IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE,
OTHER THAN THOSE EXPRESSLY DESCRIBED ABOVE SHALL APPLY. DISTRIBUTOR FURTHER
DISCLAIMS ALL WARRANTIES AFTER THE EXPRESS WARRANTY PERIOD STATED ABOVE. NO
OTHER EXPRESS WARRANTY OR GUARANTY GIVEN BY ANY PERSON, FIRM OR ENTITY WITH
RESPECT TO THE PRODUCT SHALL BE BINDING ON DISTRIBUTOR. REPAIR, REPLACEMENT,
OR REFUND OF THE ORIGINAL PURCHASE PRICE – AT DISTRIBUTOR’S SOLE DISCRETION –
ARE THE EXCLUSIVE REMEDIES OF THE CONSUMER. IN NO EVENT WILL DISTRIBUTOR OR
ITS MANUFACTURERS BE LIABLE FOR ANY INCIDENTAL, DIRECT, INDIRECT, SPECIAL,
PUNITIVE OR CONSEQUENTIAL DAMAGES (SUCH AS, BUT NOT LIMITED TO, DAMAGES FOR
LOSS OF PROFITS, BUSINESS, SAVINGS, DATA OR RECORDS) CAUSED BY THE USE, MISUSE
OR INABILITY TO USE THE PRODUCT. EXCEPT AS STATED HEREIN, NO OTHER WARRANTIES
SHALL APPLY. NOTWITHSTANDING THE FOREGOING, CONSUMER’S RECOVERY AGAINST
DISTRIBUTOR SHALL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT SOLD BY
DISTRIBUTOR. THIS WARRANTY SHALL NOT EXTEND TO ANYONE OTHER THAN THE ORIGINAL
CONSUMER WHO PURCHASED THE PRODUCT AND IS NOT TRANSFERABLE.
Some countries, states or provinces do not allow the exclusion or limitation
of incidental or consequential damages or allow limitations on warranties, so
limitation or exclusions may not apply to you. This warranty gives you
specific legal rights, and you may have other rights that vary from state to
state or province to province. Contact your authorized retailer to determine
if another warranty applies.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>