KRAMER KRT-4-M1 Table Mounting Bracket User Guide
- June 5, 2024
- Kramer
Table of Contents
KRAMER -KRT-4-M1 -Table- Mounting- Bracket
Check what’s in the box
- KRT-4-M1 Table Mounting Bracket
- 3 M4x13 Fully threaded screws for wood
- 1 Quick start guide
Get to know your KRT-4-M1
KRT-4-M1 Table Mounting Bracket enables attaching the KRT-4 Cable Retractor to
the underside of a table. KRT-4-M1 is designed mainly for RTBUS and TBUS
product lines with cable pass-through.
Install KRT-4-M1
Before installing KRT-4-M1, configure and mount a Kramer TBUS onto a table. To attach KRT-4-M1 to the underside of a table:
-
Attach KRT-4-M1 Table Mounting Bracket to the cable retractor using the Wing-Head thumb screw (see figure).
-
Position KRT-4-M1 and cable retractor underneath the table in a position close to the Kramer TBUS, ensuring that the non-retractable cable end of the cable retractor reaches the TBUS.
-
Mark the edges where KRT-4-M1 touches the table with a pencil.
-
Detach KRT-4-M1 from the cable retractor.
-
Place KRT-4-M1 so that it aligns with the pencil markings made in step 3, and using the 3 screws provided, attach KRT-4-M1 to the underside of the table.
Take care not to damage the table. Kramer Electronics is not responsible for any damage caused to the table. -
Attach the cable retractor to KRT-4-M1 Table Mounting Bracket using the Wing-Head Thumb Screw.
Specifications are subject to change without notice at www.kramerav.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>