PYLO 802-LTE Blood Pressure Monitor User Guide
- June 5, 2024
- PYLO
Table of Contents
PYLO 802-LTE Blood Pressure Monitor
Quick-Start Guide
LTE Blood Pressure Monitor
-
Insert the 4 included AA batteries into the device.Once inserted, the device will initiate an initial secure pairing with the mobile network.
-
While pairing, the symbols and will be shown. This process normally takes around 10 seconds, but may take up to a minute if signal is weak.
-
When pairing is completed successfully, the device will display the symbol and the screen will turn off. The device is now ready to use!
-
Plug the cuff tube into the device. Be sure to use the port labeled ‘Cuff Port’ and not the port for the optional power adapter.
-
Wrap the cuff around your arm and position it before tightening. Be sure to read and follow the “How to Take Your BP” guide that was included with your monitor.
-
Press the “START/STOP” button to turn on the monitor. The cuff will inflate, take a reading and then deflate. Remain still until the cuff deflates completely.
-
Your results will be displayed and saved to the device prior to transmission starting.
-
During data transmission` the symbol will flash. This process normally takes around 10 seconds but may take longer when signal weak.
-
If the transmission is a success, is shown. If connection fails, E5 or E6 is displayed. In this case, the measurement is saved and will be sent on the next succesful connection.