Shenzhen Lazy Cat Communication Technology UUMAO10W Invisible Fast Wireless Charging User Manual

: June 5, 2024
: Shenzhen Lazy Cat Communication Technology

Table of Contents

FCC Statement
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Lazy Cat Communication Technology UUMAO10W Invisible Fast Wireless Charging
User Manual

Uumao10W Invisible Fast Wireless Charging

Product Description :
This product is a wireless charging transmitter for standard QI. The minimum distance is 5MM. The maximum distance is 30MM.
Scenes To Be Used:
Suitable for installation under thick desktops. Suitable for marble, wood, glass, and other non-metallic non-conductive tables.
Charging Parameters:
TYPE-C input: 12V (please use the donated12V3A adapter)
Wireless output power: 10W/7.5W/5W,
USB wired output power: 5V2A
Effective charging distance: 5MM-30MM
How To Install:
No drilling or tools are required, you can peel off the double-sided tape on the wireless charging surface and quickly install and paste it onto the lower surface of the table. Will not cause permanent damage to your desktop or counter (optional mounting screws also included). After installing the wireless charger, use the signal detector to find the signal.
Wireless Charging Signal Detector:
When the wireless charging signal is detected, The lamp beads will light up. The brightest place is where the signal is strongest.
Safety Protection:
It has safety protection functions such as overcharge, overcurrent, and overtemperature.
Warn

1. Do not charge at a distance less than 5MM. If the receiving distance is less than 5MM, the charging and receiving equipment may be damaged.
2. Do not charge at a distance greater than 30MM. More than 30MM. It may cause Apple 12 to fail to charge. Or the phone case is too thick to charge.
3. Do not use metal or other conductors that are impermeable to electromagnetic waves.
4. Do not charge the product near or near a heat source;
5. Do not pour water or other liquids into the interface of this product, causing damage to the product; Do not allow children or animals to chew or swallow the device.
6. Do not disassemble, modify or repair the equipment.
7. Do not place magnetic stripe cards (including credit cards, phone cards, passbooks, and registration cards) near the charging equipment. In order to avoid the generated magnetic field from damaging the magnetic stripe card and damaging the device.

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is Subject To the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not explicitly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of the device, a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.