Renaisser Technology Raphael 520BT Stylus Pen User Guide

Raphael 520BT
Quick User Guide

1. Pen Tip
2. Eraser Click
3. Right Click / Power on button
4. LED indicator
5. Bluetooth Click / Power on button
6. Bluetooth indicator

How to replace the pen refill
Step 1:

• Pull out the used pen tip.

Step 2:

• Insert the pen refill.

Step 3:

• Press firmly on a hard surface for 5 seconds until the pen Refill is locked.

Start using the stylus on Surface

1. Make sure your Surface is powered on.
2. Open the Raphael 520BT package, press any button for 1 second entering the writing mode. White LED is on in working mode.
3. The red LED indicates that charging is required. When the battery is fully charged, the red LED will turn to a white LED. Raphael 520B1– will be off when the power is not enough for The user to be able to use the stylus while charging.
4. Charge for 15 minutes and use for about 70 hours. LED turns to white when fully charged.
5. Raphael 520B1 provides an intelligent power management system that automatically switches to the optimized power-saving mode and detection voltage:

• After 10 minutes without use, it will enter the power-saving mode.
• Press any button to wake up in power-saving mode.

6. Raphael 520B1 can be charged directly from the universal Micro USB cable (Sonoma).
7. Due to the characteristics of Lithium-ion batteries, it is recommended to charge the batteries once a month to avoid permanent damage to the Lithium-ion batteries at low voltage for long periods of time.

Bluetooth manual pairing

Begin the manual setup in Windows 10 (Windows 8.1 directions are also below).

1. Swipe in from the right edge of the screen, open All Settings (Windows 8.1: open Settings Charm and then tap Change PC settings).
2. Tap devices (Windows 8. 1: tap PC and devices) > Bluetooth Swipe Bluetooth to On.
3. Press and hold the top button on the Pen for 7 seconds until the LED light flashes to turn on Bluetooth pairing mode.
4. Tap [ Renaisser Pen in the list.
5. Test Bluetooth functions (using the button at the top of the Pen).

• Click to open the Windows Ink Workspace menu.
• Double click to screen sketch.
• Press and hold to add sticky notes.

6. Unpair on the paired computer to allow the new user s computer to pair with Raphael 520BT, or move away from the paired computer and re-pair again.

Safety Information

This product contains a built-in rechargeable Lithium-ion battery. It is forbidden to disassemble, crush, bend or put into the fire. Do not use it if there is serious swelling, to be exposed to high temperatures or after it has entered the water.

A Warning: Choking Hazard
This device may contain small parts which may be a choking hazard to children under 3. Keep small parts away from children.

A Caution: Personal Medical Devices
Radio-frequency emissions from electronic equipment can negatively affect the operation of other electronic equipment, causing them to malfunction. Please take the following precautions: Pacemakers The Health Industry Manufacturers Association recommends that a minimum separation of 15 cm (6 inches) be maintained between a wireless device and a pacemaker to avoid potential interference with the pacemaker. Persons with pacemakers:

• Should always keep the device more than 15 cm (6 inches) from the pacemaker when the wireless device is turned on.
• Should not carry in the breast pocket.
• If you have any reason to suspect that interference is taking place, turn the device off immediately.

FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Customer Services
services@renaisser.com
www.renaisser.com
www.facebook.com/RENAISSER

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>