Saramonic SR-BH600 Noisewall Wireless Active Noise-Cancelling Headphones User Manual

Saramonic SR-BH600 Noisewall Wireless Active Noise-Cancelling Headphones

Contents

Product Overview

Specifications

specifiction are subject to change without notice.

How to Wear

Open and wear the headphones, adjust the headphones to a comfortable position in the direction shown by the above picture.

Power On / Off

Pairing

• Press and hold for 5 seconds
• Flashing red and blue alternately
• Select “Saramonic BH600” on your device
• Voice prompts “connected”

Notes: The pairing mode will be lasted for 10 minutes. If there is no Bluetooth connection with any device for more than 10 minutes, the headphone will automatically turn off.

Button Controls

Aux-in

Switching to AUX mode once plugging in an audio cable, and Bluetooth mode will automatically turn off. When using AUX mode, control audio playback, volume and call via the connected device.

ANC On / Off

• ANC On/Slide the switch to ON/Steady green(NC LED indicator)
• ANC Off/Slide the switch to OFF/NC LED indicator off

Connect an Additional Bluetooth Devices

1. Make sure the headphones are connected to the first Bluetooth device successfully and music is not playing.
2. Hold the Multi-function Button until the headphones re-enter pairing mode (the indicator light will flash red and blue alternately).
3. Pair the headphones with the second device according to “Easy Pairing” steps.

Charge the headphones

Q&A

• Q: Failed to connect devices with headphones?
  A: Please ensure your headphones in pairing mode. Then delete the pairing record on the Bluetooth devices and reconnect with headphones.

• Q: Failed to turn on the headphones?
  A: Please check the battery status of your headphones.

• Q: Can I replace the battery in the headphones?
  A: No. These headphones use a built-in non-detachable Li-Polymer battery which can not be replaced.

• Q: Can I use the headphones while driving?
  A: For your safety, we strongly recommend you do not use headphones while driving in order to avoid distractions.

• Q: Why is the connection sometimes disconnected within 10 meters?
  A: If there are many WiFi routers, 4G signals, high-power electrical appliances and etc when using, it may be interfering with the Bluetooth connection. It can be solved by changing the environment or reconnecting.

• Q: No sound from my computer or mobile phone?
  A: Please check if the output channel of your computer supports the A2DP profile. Also check the volume settings on your headphones and computer/mobile phone.

• Q: Why am I unable control the volume of a track playing on my mobile phone’s APPs?
  A: The configurations of various application softwares are different, the headphones may not be completely compatible with some APPs.

• Q: What should I do if the Bluetooth connecting function cannot close or open?
  A: Please reset the Bluetooth function of the headphones by inserting an audio cable into the audio port and removing it.

• Q: Why does Bluetooth turn off when I connect an audio cable?
  A: This is one of BH600 special features. When the user inserts an audio cable into the audio port, all Bluetooth feature buttons temporary stop working and Bluetooth turns off. The Bluetooth will be available again when pulling out the audio cable.

• Q: Failed to turn the headphones on/off?
  A: Please noted that ANC and Bluetooth are indicated by the same indicator light, with a green light for ANC and a blue light for Bluetooth. If you need to turn Bluetooth on/off, please make sure you already turn off the ANC.

FCC WARNING

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate = radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure. requirement.The device can be used in portable exposure condition without restriction

Safety Instructions

1. Read, follow and keep these instructions.
2. For the best possible experience, always use the product as described by the manufacturer.
3. Always handle your headphones with care and protect them from external damage.
4. Clean your headphones using a soft dry cloth. Never use water, cleaning detergent, leather polish or other substances as they may damage your headphones permanently.
5. Avoid exposure to extreme conditions such as very cold or hot temperatures, mahnetic fields or damp environments.
6. Listening to music at high volume for prolonged periods of time can cause permanent damage to your hearing.
7. Contains small parts and are not suitable for children age three (3) and below.
8. The headphones contain magnetic material.
9. The headphones contain a Lithium battery. If misused or damaged it can become a hazard and is at risk of explosion.
10. Should a battery cell leak, do not allow the liquid to come in contact with skin or eyes.
11. The headphones must be switched off before boarding an aircraft.
12. The headphones must not be disposed of with regular household waste. Please dispose of in accordance with local regulations.
13.  Do not use your headphones in the immediate proximity (10 cm) of a pacemaker.
14. Do not subject the product and included accessories to abnormal wear and tear.
15. Do not expose the headphones to temperatures below -20°C or above +45°C.
16. Do not charge the headphones in temperatures below 0°C or above +45°C.
17. Do not attempt to burn the headphones. The battery could explode causing injury and death.
18. Do not attempt to open, modify, disassemble, repair or in other way access the internal structure of the headphones. They are not user serviceable.
19. Do not use or store the headphones near to a vehicle airbag due to risk of injury.
20. Do not use headphones while driving, jogging or walking through traffic areas. Headphones effectively isolate external sound and noise, which means that when in use, you might not be able to hear your surroundings.
21. Do not drop, sit on or cause other unusual impact to the headphones.
22. Do not expose to fire, water or high voltage equipment.
23. Do not expose the product to rain or moisture.
24. Do not use the headphones near water, bathtubs, sinks, saunas, pools, other liquids or moist areas.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>