Fuyun Acoustics Technology P2 True Wireless Stereo Earbuds Instruction Manual
- June 5, 2024
- Fuyun Acoustics Technology
Table of Contents
Fuyun Acoustics Technology P2 True Wireless Stereo Earbuds
Functional Operation Instructions
-
Power On/Off
Power on: Open the top cover of the charging case, the earbuds will automatically turn on;
Power off: Put the earbuds into the charging case and close the cover of the charging case, to shut down the earbuds -
Charging Case Button Function
1. Put L & R earbuds into the charging case, then open the top cover of the charging case. Press the button and hold for 3 seconds, then the white indicator LED flashes. and the earbuds enter the Bluetooth pairing mode. Search for “FY Buds” with the mobile phone and select the connection.If the connection is okay, the green indicator LED will be on for 5 seconds.
2. Put L & R earbuds into the charging box, then open the top cover of the charging case. Press the button and hold for 10 seconds, then the red indicator LED flashes, and the factory settings are restored.Functional Operation Instructions
- Earbuds Function
- L & R Earbuds TWS Pairing Put L & R earbuds into the charging case, and press the button for 5 times to enter the pairing mode for L & R earbuds,then the yellow indicator LED flashes for 3 times. Search for “FY Buds” with the mobile phone to select the connection.
- Headphone Operation Instructions
- Earbuds IR Function Description
- During the call status: When the single earbud is removed from the ear, the call is transferred to the other earbud. The dual earbuds are removed from the ear, the call is transferred to the mobile phone. And the earphone is inserted into the ear again, the call will be transferred to the earbuds.
- During the music playing status: When the earbud is removed from the ear, the music is paused.When the earbud is in the ear again, and the music resumes.
Call Operation
Play Music
FCC Rules
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment The device has been evaluated to meet general RF exposure requirements the device can be used in portable exposure conditions without restriction